1.
Analysis on and Treatment of Oil Leakage of Bearing Box in ACF Axial Mine Ventilating Fan
AGF轴流式通风机轴承箱漏油的分析与处理
2.
The four places in the automobile from which pollutants can escape are the fuel tank, carburetor, crankcase and tail pipe.
汽车内泄漏污染物的四个位置是燃油箱、化油箱、曲轴箱和尾管。
3.
Treatment of Oil Leakage in the Main Bearing of MTZ32/47 Coal Pulverizer
MTZ32/47型磨煤机主轴承漏油现象的治理
4.
Use of the bearing oil leak detector will determine whether or not bearing wear has been uneven.
使用漏油检测装置即可判定轴承磨损是否均匀。
5.
The Reason and Solvi ng Measures of Oil Leaking in Bearing Pedestal of Centrifugal FD Fan
离心式送风机轴承座漏油的原因及处理
6.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
7.
The oil is leaking out from the crankcase.
没已从曲轴箱中漏出来。
8.
Oil be seep out through a crack In the tank
油箱的裂缝漏出油来了
9.
Oil is seeping out through a crack in the tank.
油箱的裂缝漏出油来了.
10.
"On many engines, the connection-rod and main bearings (crankshaft bearings) can be checked for wear with an oil-leak detector before the engine is torn down."
许多发动机在拆卸之前,可以用漏油检测装置检查连杆和主轴承(曲轴轴承)的磨损情况。
11.
The detector manufacturer states that a normal bearing will leak between 20 and 150 drops of oil a minute.
这种装置的制造厂商指出,标准轴承每分钟应漏油20～150滴。
12.
Frictional Performance and Leakage of Ball Bearings Lubricated by Chlorphenyl Silicone oil in Vacuum
氯苯基硅油润滑球轴承在真空环境下摩擦性能与泄漏量研究
13.
Analysis and Solution of Endshield-type Oil Leakage in High-Speed Motor
高速端盖式滑动电机轴承漏油问题的分析与解决措施
14.
groove-cutting chisel
槽刨, 油槽铲(轴承)
15.
Remove side bearings from differential case.
拆卸差速箱处的侧轴承。
16.
The reducer housing design allows oil from all bearing cavities to be drained through the sump during routine maintenance.
在检修时，减速箱的设计允许润滑油从所有轴承空间排出，进入机油箱。
17.
emergency bearing oil pump
紧急备用轴承油泵应急轴承油泵
18.
crankcase oil foaming
曲轴箱润滑油起泡沫