1.
single plane mean outside diameter deviation
单一平面平均外径偏差
2.
Polypropylene (PP) pipes-Tolerances on outside diameters and wall thicknesses
GB/T13019-1991聚丙烯(PP)管材外径和壁厚极限偏差
3.
Polyethylene (PE) pipes-Tolerances on outside diameters and wall thicknesses
GB/T13018-1991聚乙烯(pe)管材外径和壁厚极限偏差
4.
Tolerance of Wire Diameters & Ovality
圆径及偏圆度之公差
5.
limit deviation of root circle diameter
齿根圆直径极限偏差
6.
single plane mean bore deviation
单一平面平均内径偏差
7.
Unplasticized polyvinyl chloride (PVC-U) pipes-Tolerances on outside diameters and wall thicknesses
GB/T13020-1991硬聚氯乙烯(PVC-U)管材—外径和壁厚极限偏差
8.
Common screw thread deviation table
GB/T2516-1981普通螺纹偏差表(直径1~355mm)
9.
Diameter Tolerance, Ovality and Average Decarburized Layer Depth
直径公差，偏圆度及脱碳层的平均深度
10.
A Cognitive-Ecological Sampling Approach To Judgment Biases;
判断偏差分析的认知-生态取样途径
11.
Analysis on the Deviation of Evaluation in TCSL and the Countermeasure to Rectify the Deviation;
对外汉语教学评估偏差分析及纠偏对策
12.
Radial runout is the difference between the high and low points on the tire or wheel.
径向偏摆是指轮胎或车轮上的高低点之差异。
13.
The Compensation for the Doppler Spectrum Centroid Deviation of the SAR
合成孔径雷达多普勒频谱偏移误差的补偿
14.
The deviation from the root of the economic growth depending on and the Policy of the correct;
经济增长中的路径依赖偏差及矫正对策
15.
The Analysis of Forecast Deviation of The Southwest Vortex Track And Nnumerical Simulation
一次西南涡路径预报偏差分析及数值模拟
16.
Problems Caused by Coil Diameter Calculation Deviation and Improving Scheme
冷轧出口卷径偏差引出的问题及改进方案
17.
Reasons Analysis of the Inaccuracy of Stock Merchants' Research Report and the Improvement Approaches
券商研究报告偏差的原因分析与改善途径
18.
The progress variance analysis model distinguishing the critical and non-critical path
区分关键路径与非关键路径的项目进度偏差分析模型