1.
Drilling machines-Spindle noses
GB/T2815-1989钻床主轴端部
2.
Dimensions of spindle ends for manually operated electronic components
GB/T2775-1993手控电子元件的轴端尺寸
3.
distance from spindle nose to central line of table
主轴端面至工作台中心线距离
4.
Lock rings at the end of shaft with scre
GB/T891-1986螺钉紧固轴端挡圈
5.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
6.
hub cap for road motor vehicles or tractors
轴端盖,道路机动车辆或摩托车用
7.
Remove vibration damper bolt and washer from end of crankshaft.
从曲轴端拆下减震器螺栓和垫圈。
8.
Retrofit of the Low-pressure Shaft Butt Seal in 51-50-3 Type Steam Turbine
51-50-3型汽轮机低压轴端汽封的改造
9.
fan end thrust ball bearing
风扇端止推滚球轴承
10.
axial double mechanical seal
轴向双端面机械密封
11.
SMALLER DIAMETER OF PIVOT BEARING
轮毂轴承的较小直径端
12.
End play in drive pinion bearings.
驱动小齿轮轴承的端隙。
13.
vertical -spindle double ended grinding mahcine for piston ring
活塞环立轴双端面磨床
14.
horizontal spindle double ended grinding machine for piston ring
活塞环卧轴双端面磨床
15.
Pressure-compensated air bearings are used on both ends of the trunnion axis.
耳轴两端各用一压力补偿空气轴承。
16.
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
17.
The dates you specified for the axis values can't be used, because the maximum axis value must occur at a later date than the minimum axis value.
为坐标轴指定的日期非法。坐标轴远端的日期必须晚于近端的日期。
18.
Either extremity of an axis through a sphere.
（轴的）两极穿过一个球体的中轴的两端中的任一端