1.
Simulation of Heat Transfer in Cryogenic Treatment and Design of a Test System for Cryogenic Valves;
深冷处理传热模拟及低温阀门试验系统设计
2.
Pressure testing for general purpose valves
GB/T13927-1992通用阀门压力试验
3.
All safety valves will undergo popping tests by the Licensee.
所有安全阀门将由被许可方进行爆裂试验？
4.
Study on Complicated Separation Flow Behind the Reversed Tainter Valve of the Filling and Emptying System for Navigation Lock;
通航船闸输水阀门后复杂分离流试验研究
5.
Research on Energy-Saving Technology of Utilizing Residual Pressure by Valves Regulating on Water Supply
阀门控制利用管网余压供水节能试验研究
6.
They shut off valves to prevent steam from reaching the turbine-generating unit they intended to test.
他们关上阀门不让蒸气流到他们要试验的蒸汽锅轮发电机组。
7.
Heat Transfer Simulation in Cryogenic Test of Cryogenic Valves and Development of a Test System for Cryogenic Treatment;
低温阀门冷态试验过程传热模拟及深冷处理设备研制
8.
Experimental Study on Control Management and Commissioning of Sequencing Valve for High-Voltage Steam Governing in 600MW Supercritical Units
600MW超临界机组高压调节汽门顺序阀控制管理及投运试验研究
9.
The trim valves of the confirming flow test.
应该确认这些阀门通过流量测试。
10.
Experimental Research on Effect of Electromagnietic Valve s Structure on Water Hammer;
电磁阀阀芯结构对水锤影响的试验研究
11.
Numerical Simulation of the Sound Field and Experiment Research of Valve Inner Leakage;
阀门内漏的声场数值模拟及实验研究
12.
"For very precise flow measurements, test must be conducted on any valve mentioned within this website"
如果需要精确的测量数据,必须对本网站所提到的任何阀门进行试验。
13.
The Research of 120 Distributing Valve Test Performance and Standard on Two Test Rigs
120阀在两种试验台上试验性能及标准对比研究
14.
Safety valve test and safety valve testing bed
安全阀试验规定及其试验装置的分析与研究
15.
There shall be semi-auto change over system in the gas yard and main pressure valve and relief valves should be located outside the lab building.
安装半自动转换阀控制气瓶更换，主要的控制阀门和减压阀门都安装在实验室外。
16.
Specification for selection inspection and acceptance of steel valves used in petrochemical industry
石油化工钢制通用阀门选用、检验及验收
17.
Type of valve- gate, globe, check, etc.
阀门种类：闸阀，截止阀，止回阀，蝶阀，球阀，等等。
18.
Performance test methods for safety valves
GB/T12242-1989安全阀性能试验方法