1.
CHANGING OF DEWPOINT PRESSURE FOR CONDENSATE GAS IN GAS INJECTION
凝析气藏注气过程中露点压力变化特征研究(英文)
2.
The Effect of Oxygen Drop on Combustion Process Gas-Gas Injector
氧压降对气-气喷注器燃烧过程的影响
3.
What should be paid attention to in the overhaul of cylinder?
在气缸大修过程中应该注意什么？
4.
Research on the Usability of Underground Salt Rock Gas Storage in the Process of Gas Injection and Production
注采气过程中地下盐岩储气库可用性研究
5.
Influence of Particles in the Air to Transfusion Quality in Process of Infusion
环境空气微粒对输注过程输液质量的影响
6.
Corrosion and Anti-Corrosion Techniques for Air Injection EOR Process
注空气驱油过程中的管柱腐蚀与防腐工艺研究
7.
Attention problems during the installation process of centrifugal air compressor
离心式空气压缩机组安装过程中应注意的问题
8.
Design of Running System of Cylinder Block and Simulation of the Forming Process
气缸体浇注系统的设计与成形过程的模拟
9.
Study on Photoionization Produced by Discharge in Atmospheric Air by Numerical Method
大气压下流注放电光电离过程的数值仿真
10.
The act or process of furnishing critical commentary or explanatory notes.
注解，注释，评注评注或注解的行为或过程
11.
Open several hot water faucets to allow air to escape from the system while the heater if filling.
打开几个热水水龙头,让热水管道中的气体在注水过程中排放出来。
12.
During IOR by gas injection, asphtene precipitation will commonly block the effect of IOR.
在注气提高采收率过程中，沥青沉降经常严重妨碍了采收率的提高。
13.
The Solution of the Oil Injection Pipeline Clamps for Vacuum Impregnation of Capacitor
电容器真空浸渍过程中注油管路夹气问题的解决
14.
registered gas contractor
注册气体工程承办商
15.
Hydraulics model is built by using similar theories, which simulates the process of air entrainment of tapping.
利用相似原理建立水力学模型，模拟了出钢过程中注入流体卷入气体的过程。
16.
The act or process of enrolling.
登记，注册登记注册的行为或过程
17.
Study on Injection Energy Consumption in the Injection Molding Machine Experimental System;
注射机实验系统注射过程能耗的研究
18.
These levels of indoor air pollutants may be of particular concern because most people spend about 90％ of their time indoors.
由于多数人大约90％的时间都在室内度过，室内空气污染的这种程度应当引起人们的特别关注。