1.
Computer Interpretation of Line Drawings for Representing Planar Objects under Axonometric Projection;
平面立体正轴测线框图的计算机解释研究
2.
Measure bearings for correct clearance
测量轴承以校正间隙
3.
Introducing The Coefficient of Asle Direction Changed Shape andthe Size of Angle Between Axle and Asle From the Formation of Posi-tive Equal AnoprojEction
从正等轴测图形成过程分析轴向变形系数和轴间角的大小
4.
orthogonally mounted accelerometer
测量轴正交安装的加速度表
5.
A Method in Proportion to drawing ellipses in dimetric projection;
正二测轴测图中椭圆的八点比例作图法
6.
Mathematic Model of Axis Deviation Influence on Surveying Angle and Its Correction;
轴系偏差对测量角影响的数学模型及改正方法
7.
Research of Coaxial Measurement and Calibration Technology Based on LD/PSD;
基于LD/PSD同轴度测量与校正技术的研究
8.
Modification of altitude axis errors for 1 m aperture telescopes
1m望远镜俯仰轴系精度检测误差的修正
9.
Improvement of optical axis parallelism correction for laser rangefinder
关于激光测距机光轴平行性校正方法的改进
10.
Research on Non-orthogonal Error Analysis and Measurement Method of Three-axis Magnetic Sensor
三轴传感器非正交性误差分析及测量方法研究
11.
A new tracking algorism for single detector compound axis was presented and realized based on realtime trajectory correcting.
提出并实现了基于实时预测轨迹修正的单检测型复合轴控制方法。
12.
(geometry) the angle formed by the x-axis and a given line (measured counterclockwise from the positive half of the x-axis).
（几何）X轴和一条直线所形成的角（从X轴的正方向按逆时针方向测量）。
13.
Test methods for communication cable--Measurement of actual length of coaxial pair--Sine wave method
GB/T5441.10-1985通信电缆试验方法同轴对展开长度测量正弦波法
14.
The Method of Detecting and Correcting Oblique License Plate Based on the Corner Points Information and Inertial Principal Axis
采用角点信息和惯性主轴的车牌倾斜检测与校正方法
15.
axial flow reversing gas turbine
轴流式正倒车燃气轮机
16.
He is welding the pieces of a broken axle.
他正在焊接断了的车轴。
17.
alignment of bottom casing and bearing seating
下汽缸和轴承座找正
18.
inverse cylindrical orthomorphic chart
横轴圆柱正形投影图