1.
Service Life Analysis for the Thick-wall Components of the 600MW Supercritical Boiler
600MW超临界锅炉厚壁部件寿命分析
2.
Brittle fracture sensitivity analysis on thick-walled metal parts of (ultra) super critical unit
超(超)临界机组厚壁金属部件脆性断裂敏感性分析
3.
The Research of Instrument for Measurement of Wall-thickness and Wall-thickness Difference of Thin-wall Parts of Variation Curvature Revolving Body;
变曲率回转体薄壁零件壁厚及壁厚差测量仪的研究
4.
Thin-Walled Part of Variable Wall Thickness Machining Modeling and Its Experimental Study
薄壁变壁厚零件切削加工建模及其实验研究
5.
Applying Software Repeatedly in the Calculation of Tube's Thickness of the High-pressure Pipage
高压输送管路壁厚计算中的软件复用
6.
Analysis on Thickness of Pressure-lubricating Deep Drawing of Magnesium Alloy Cylindrical Cups
镁合金筒形件压力润滑拉深壁厚分析
7.
The ironing process with thinning in wall thickness and reducing in diameter
壁厚变薄直径缩小空心件的变薄拉深
8.
Thousands of installations demonstrate the reliability and suitability of these simple and effective tools for sand production.
本机具有可更换磨损件，厚壁管和轴，带隔离结构下部轴承和特重负荷齿轮箱。
9.
A ledge or recess in a wall formed by a reduction in thickness above;a setoff.
壁阶为缩减其上方墙壁的厚度而形成的墙壁狭长部分或凹处
10.
Experimental Study and Theoretical Analysis on Load Carrying Apacity of Cold-Formed Flexural Members with Thicknesses Less Than 2mm;
壁厚小于2mm冷弯薄壁型钢受弯构件承载力试验研究及理论分析
11.
Experimental study on behavior of cold-formed steel flexural members with thickness less than 2mm
壁厚2mm以下冷弯薄壁型钢受弯构件性能试验研究
12.
Enclosures for protection against ionizing radiation Lead shielding units for 50mm and 100mm thick walls?
壁厚为50mm和100mm的防电离辐射包壳的铅屏蔽构件
13.
Production of thick section and high strength casting using low alloy cast iron
利用低合金铸铁生产厚壁高强度铸件的研究
14.
Wire-DEM on the Heavy-Thickness and Thin -Wall Alumium Alloy Special Parts
铝合金大厚度薄壁异形件的线切割加工
15.
Research on Manufacturing Engineering and Special Equipments of the High Pressure-Resistant, Large-calibre and Thick-wall Pipe Fittings;
高压大口径厚壁管件制造工艺及专用设备研究
16.
Theoretical Analysis of Residual Stress in Thick Cold-Formed Steel Members
厚壁冷成型钢构件残余应力的理论分析
17.
Defect Solution of Gas-Assisted Molding for Thick-Wall Plastic Part Based on DOE
基于DOE厚壁零件气辅成型缺陷的解决途径
18.
Influence of Temperature on Parts` Wall Thickness and Properties in Extrusion Blow Molding
温度对挤出吹塑制件壁厚分布及性能的影响