1.
Based on the simulating result of FEM numerical experiment, this paper investigates the effect of local buckling on the hysteretic behavior of tubular columns under cyclic unaxial load.
根据有限元模拟的结果,分析了板件局部屈曲对方管截面柱拉压滞回性能的影响。
2.
Study on Concrete-filled Square Steel Tubular Column and L-shaped Column Composed of Concrete-filled Square Steel Tubes;
方钢管混凝土柱和L形截面方钢管混凝土组合异形柱研究
3.
The Research on Bearing Capacity of Steel Tube Composite Column Filled with Steel Reinforced Concrete;
钢骨—钢管混凝土柱正截面承载力计算方法研究
4.
Simplified Calculation Method of Section Temperature Field of Concrete Columns with Steel Tubes
钢管混凝土柱截面温度场的简化计算方法
5.
Study on Load Bearing Capacity of Crisscross Section Column Composed of Concrete-filled Square Steel Tubes;
十字形截面方钢管混凝土组合异形柱承载力研究
6.
Study on the Method for Calculation of Flexural Strength of Composite Column with Core of High-Strength Concrete Filled Steel Tube;
钢管高强混凝土核心柱正截面承载力计算方法研究
7.
The vertical stiffener connection is suitable for rectangular steel tube column that the sectional area is smaller and H-steel beam connections.
垂直加劲肋节点适于柱截面较小的方钢管（矩形管）柱和H型钢梁节点。
8.
Location measurement of circular rod in glass tube
玻璃圆管中圆形截面杆柱位置的测定
9.
Experimental study on normal section compression bearing capacity of composite T-shaped concrete-filled steel tubular columns
组合T形截面钢管混凝土柱正截面受压承载力试验研究
10.
Simulation of Bond Stress in Short Cfst Column with Dumbbell-Shaped Section;
哑铃形截面钢管混凝土短柱紧箍力模拟
11.
A DIRECT METHOD FOR SECTION DESIGN OF SQUARE COLUMNS CONSISTING OF FOUR EQUILATERAL STEEL ANGLE
等边角钢四肢方阵式格构柱截面直接设计法
12.
Study on Design of Welded H-column under Axial Compression;
焊接H形轴心受压柱截面设计方法研究
13.
Elastic buckling loads of shuttle tube steel columns with uniform cross section in the middle part under axial force
中部等截面轴心受压梭形钢管柱的弹性屈曲荷载
14.
Generalized Method of Solution to Inherent Frequencyof Column that Have the Same Section and Qualityof Even Distribution Oscillating in Miniamplitude
计算均质等截面柱体微幅摆动固有频率的一般方法
15.
Studies on Stability Behavior and Design Method of Shuttle-Shaped Axially Loaded Column;
梭形变截面轴心受压柱的稳定性能与设计方法研究
16.
Direct Strength Method Study on High Strength Cold-Formed Steel Squared Axial Compression Columns with Stiffened Elements;
高强冷弯薄壁型钢方形加劲截面轴压柱直接强度法研究
17.
The Research on the Strength of Normal Section and Inclined Section of Steel Reinforced Concrete Special-Shaped Column;
钢骨混凝土异形柱正截面与斜截面承载力研究
18.
Calculation of Bearing Capacity of Axial Compression Short Column with Round Cross-Section Reinforced by Enlarging Cross-Section Method
扩大截面加固轴心受压圆截面短柱承载力计算