1.
Discussion on Wheel and Axle Maintenance Technology and Equipment of Railway Multiple Units
对铁路动车组轮轴检修工艺及装备的探讨
2.
Research on and Practice of the Scientific Repair of Cylinder Bearing of Large Shafttower Friction Winder
大型井塔式摩擦轮提升机滚筒轴承科学检修研究与实践
3.
Analysis of Common Inspection and Repair of 353130B Bearings
353130B型轴承一般检修分析
4.
Check/correct flywheel alignment.
检查/修正飞轮校正。
5.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
6.
This article gives a fatigue analysis of the subway vehicle wheel shafts and discusses the reasons why these shafts should be repaired.
对地铁车辆轮轴进行了疲劳分析，给出了轮轴必须修复的原因。
7.
If the axle shaft and hub bearing are being removed in order to service another component, the axle shaft and hub bearing can be removed as an assembly.
如果维修时需拆卸主动轴和轮毂轴承，主动轴和轮毂轴承可作为一个总成加以拆卸。
8.
Research on High Accuracy Inspection of Train Wheel-set Journal Diameter;
机车轮对轴径高精度检测方法的研究
9.
The Design of the Self-Balance Two Wheel Vehicle's Attitude Estimation System
单轴双轮自平衡车姿态检测方案设计
10.
Discussion and Practice of Rear Bearing Maintenance on Sub-critical 600 MW Generator
上汽厂亚临界600MW机组尾部轴承检修
11.
Check the deflection of the crankshaft both before and after repair.
在修理前和修理后都要检查曲轴的变形情况。
12.
"Valve Service and Maintenance includes installing new seat inserts, cleaning or replacing valve guides, servicing the camshaft and camshaft bearings, and timing the valves."
气门维修包括镶配气门座,清洁或更换气门导管,保养凸轮轴和凸轮轴轴承,气门的正时调整。
13.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床
14.
The Pulse Electronics Brush Plates the Repair Rolling Mill Tooth Wheel Axle to Brush Plates the Craft Practice
脉冲电刷镀修复轧机齿轮轴刷镀工艺实践
15.
Cause Analysis of Turbine Rotor's Shaft Neck Damage and the Repair
汽轮机转子轴颈损伤原因分析及修复措施
16.
Analysis of Damage Cause and Repair for the Main Bearing Host of M/V IRIS
IRIS轮主机主轴承座损伤原因分析及修理
17.
Dynamic Analysis of Spindle of Form Grinding Wheel Dressing Device Based on ANSYS
基于ANSYS的成形砂轮修整装置主轴动态分析
18.
Drive shafts modified for new location on the axle housing and because of the new doubler. Double joint added to the front drive shaft and the shaft made longer. Rear drive shaft shortened.
传动轴修改来配合分动箱放大齿轮组。改装内容包括双十字轴和加长前传动轴。后传动轴截短。