说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 曲轴主轴承
1.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
2.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
3.
Study on Load Analysis Method for Diesel Engine Crankshaft Main Bearing Based on ADAMS;
基于ADMAS的柴油机曲轴主轴承载荷分析方法研究
4.
Study on Lubricating Characteristics of Crankshaft Main Bearing for High-duty Diesel
高强化柴油机曲轴主轴承润滑特性研究
5.
Crankshaft and main bearings service
曲轴和主轴承的维修
6.
crankshaft (main journal turning lathe)
曲轴(主轴颈)车床
7.
MAIN BEARING JOURNAL DIAMETER (CRANKSHAFT REMOVED)
主轴承颈部直径(曲轴已卸去)
8.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
9.
"This section describes the servicing of crankshafts, main bearings, and engine Blocks and cylinders."
本节介绍曲轴、主轴承、发动机机体和气缸的维修。
10.
Main Bearing Lubrication Analysis Considering Crankshaft Elastic Deformation and Asperity Contact
考虑曲轴倾斜和摩擦接触的主轴承润滑分析
11.
Crankshaft main journal out of round or worn
曲轴主轴颈不圆或磨损
12.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
13.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
14.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
15.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
16.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
17.
"Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out."
半精加工的主轴承安装后需要修整和调配,这样曲轴就必须拆下。
18.
"On many engines, the connection-rod and main bearings (crankshaft bearings) can be checked for wear with an oil-leak detector before the engine is torn down."
许多发动机在拆卸之前,可以用漏油检测装置检查连杆和主轴承(曲轴轴承)的磨损情况。