1.
Cause Analysis to Incompletely Divide-shut Brake and Heating of GW10-252 Type Isolating Switch
GW10-252型隔离开关分合闸不到位及发热原因分析
2.
Measurement and Analysis of Dynamic Deformation of SF_6 Circuit Breaker’s Insulated Pull Rod for On-off Operation
SF_6高压断路器分合闸绝缘拉杆动态形变的测试分析
3.
Analysis on false switch-in and failure switch-off of 10 kV generator's outgoing switch and treatment measures
10kV发电机出口开关误合闸及拒绝分闸故障分析与处理
4.
Analysis for the Abnormal Phenomenon of the Closing Time in the 500 kV Circuit Breaker
500kV断路器合闸时间异常情况分析
5.
Analysis of Causes to Breaking of the Steel Backs of Composite Brake Shoes and Suggestions
合成闸瓦钢背断裂的原因分析及建议
6.
Cause Analysis and Countermeasures to Burnout of Tripping and Closing Coil of Circuit Breaker
断路器分、合闸线圈烧毁原因分析及对策
7.
To prevent the breaker against closing operation when the breaker is in OFF state.
当断路器处于分断状态下，防止断路器合闸。
8.
Analysis and Solution of the Looseness Fault in Breaker’s Closing Coil Static Iron Core
断路器合闸线圈静铁芯松动故障的分析处理
9.
Study on Reclosure Technique Based on Branch Transient Potential Energy;
基于支路暂态势能分析的重合闸技术研究
10.
Development of Switching Overvoltage Analysis Software for Transmission-Line Energization in Black-Start Process;
黑启动路径空载合闸过电压分析软件的开发
11.
Single-pole Adaptive Reclosure Based on Transient Component;
基于暂态分量的自适应单相自动重合闸研究
12.
Analysis and Calculation of the Allowed Values of Contact Pressures during the Circuit Breaker Closed Work;
断路器合闸过程触头压力允值的分析计算
13.
Analysis and improvement about a case of recloser miss operation when switch secret trip
一起开关偷跳重合闸不动作的分析和改进
14.
Analysis of an incorrect operation of 500kV line reclosing device and prevention method
500kV线路重合闸不正确动作分析与防范措施
15.
Switching Over-voltage Verification and Simulation of Unloaded Line in Black-start Scheme
黑启动方案的空载合闸过电压分析与仿真
16.
Analysis of switching on with no load and pre-excitation of marine high-capacity transformer
船用大容量变压器空载合闸及预充磁分析
17.
Analysis of protection incorrect operation caused by non-charging after reclosing
重合闸未充电引发保护不正确动作的分析
18.
Reason Analysis on Switching Coil Burning in 10kV Vacuum Breaker
一起10kV真空断路器合闸线圈烧损的原因分析