1.
Error Analysis of Radar Angle of Pitching Based on Troposphere Electric Wave Propagation
基于对流层电波传播的雷达俯仰角误差分析
2.
Analysis and Evaluation of Naval Laser Communication Transmission Declination Angle
舰载激光通信传输仰角误差分析与评估
3.
Method of radio wave refraction error correction based on 0 deg and its nearby elevation angles
0度及其附近仰角的电波折射误差修正方法
4.
Modification of altitude axis errors for 1 m aperture telescopes
1m望远镜俯仰轴系精度检测误差的修正
5.
A SINS Nonlinear Error Model Reflecting Better Characteristics of SINS Errors
基于欧拉平台误差角的SINS非线性误差模型研究
6.
The Reflected Beam's Phase Aberration Induced by the Fabrication Errors of Corner Cube Retroreflector
角锥棱镜的误差引起的反射光束相位误差分析
7.
An Algorithm Based on Differential Preprocessing of Low Elevation Estimation in VHF Radar
基于差分预处理的米波雷达低仰角处理算法
8.
This article discussed the method to reduce the error of the calculation from three aspects: error by not in-phase, difference in sample frequency and ideal sample frequency, and finite register length effects.
本文从减小同步误差、小频差序数和减小舍入误差等三个方面入手,减小功率因数角的计算误差。
9.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
10.
The Optical Lever Enlarging Method Produced Error Because of the Angle;
光杠杆放大法测量中α角产生的误差
11.
Simulation Analysis of Phase-compare Angle Measurement Error Caused by Multipath over Sea Surface
海面多路径下比相测角误差仿真分析
12.
Covariance Analysis of Missile-to-Target LOS Pointing Angle Error for SAM
地空导弹弹目视线指向预定角误差协方差分析
13.
The ACS switches from mode7 to mode3 when mode7 is not able to maintain a small elevation error while dealing with the azimuth error at the same time.
当模式7在处理方位角错误时无法同时维持较小的仰角错误时，ACS会从模式7转换成模式3。
14.
A Novel Polarization Angle Sensor and Error Compensation Algorithm for Navigation
新型仿生偏振测角传感器及角度误差补偿算法
15.
Effect of Helix Angle Errors on Transmission Error of Double Circle Arc Helical Gears
双圆弧齿轮的螺旋角误差对其传动误差的影响分析
16.
Through polar coordinate method error calculus demonstrated that the setting-out point error is mainly caused by angle measurement error.
通过对极坐标法误差的计算论证了放样点误差主要是由测角误差引起。
17.
alignment error
安装误差;调准误差;定线误差;校正误差;校直误差
18.
Secondly there is error between thethread roll angles of thread rolling die and drill rod.
滚丝轮螺纹和钻杆螺纹的螺旋角有误差。