1.
Support Axial Force Servo System in Deep Excavation Deformation Control
控制深基坑变形的支撑轴力伺服系统
2.
Grey Relational Analysis of Strut Force and Water Level and Temperature
支撑轴力与地下水位、气温的灰色关联分析
3.
Discussion on Monitoring Accuracy of Axial Force of Concrete Bracing of Metro Foundation Pit Works
对地铁基坑混凝土支撑轴力监测精准性的探讨
4.
On Deformation of Envelop Enclosure and Monitoring on Supporting Axial Forces of Deep Excavation
基坑开挖中围护结构变形和支撑轴力的监测
5.
Study on Field Measurement of Support Axial Force and Deformation of Retaining Structures during Super-width Deep Excavating
超宽深基坑开挖与支撑轴力和围护结构变形现场实测研究
6.
It is necessary to consider the influence of shrinking and temperature stresses when using reinforced stress to measure reinforced concrete strut axial forces.
采用钢筋应力计量测钢筋混凝土支撑轴力时，收缩应力和温度应力修正是必要的。
7.
Abstract: It is necessary to consider the influence of shrinking and temperature stresses when using reinforced stress to measure reinforced concrete strut axial forces.
文摘:采用钢筋应力计量测钢筋混凝土支撑轴力时，收缩应力和温度应力修正是必要的。
8.
Hysteretic Behavior of Concrete-Filled Steel Tubular Columns Brace under Varible Axial Force;
变轴力下钢管混凝土支撑滞回性能的理论研究
9.
Research on Layout of Inclined Viscous Damping Brace from Additional Column Axial Force
从附加柱轴力探讨斜置阻尼支撑的布置原则
10.
Analysis of Deformation of Double-disk Supported Thrust Bearing for Hydrogenerators
水轮发电机双托盘支撑推力轴承变形分析
11.
REACTION SHAFT SUPPORT SEAL RINGS.
从动轴支撑封印环。
12.
stub-supported coaxial
短截线支撑的同轴线
13.
An axis or shaft supporting a rotating part on a lathe.
柄轴，心轴支撑车床旋转部件的轴或杠
14.
Simple support;Resilient support;Adjustable support;Roller support;Anchor
简单支撑点;弹性支撑点;可调支撑点;滚轴支撑点;锚点
15.
a brace that extends from the rear of the keel to support the rudderpost.
从龙骨后部延伸出的支撑舵轴的支柱。
16.
Taper support rib usually two or three cam roller contacts, in order to edge into the axis of rotation to be sent to the uniform output shaft.
锥度支撑肋通常与两个或三个凸轮滚子接触，以便入力轴的旋转可均匀地传送到出力轴。
17.
Bushings: Furnishes shaft support at three locations for positive shaft alignment and actuator support.
衬套:在三个位置上配置轴支撑,有利于轴校直和执行机构的支撑。
18.
Bushings (4): Furnishes shaft support at three locations for positive shaft alignment and actuator support.
衬套（4）：在三个位置上配置轴支撑，有利于轴校直和执行机构的支撑。