1.
By using this ratio, mean distance between probe and target surface was estimated.
根据这一比值可以实现探头与被测表面间距离的估计。
2.
The distance between the head of a recording device and the surface of the recording medium.
录音间隙录音磁头和录音媒体表面之间的距离
3.
Total Indicator Reading( TIR)- The smallest distance between planes on the surface of the wafer.
总计指示剂数(IR)-晶圆片表面位面间的最短距离。
4.
The Calculation Methods of Distance between Two Points on The Earth s Surface;
地球表面上两点之间距离的几种求算方法
5.
Study of Surface Lattice Interval Transformmation of Epitaxial GaN-based Films by Using RHEED;
从RHEED图像间距分析外延GaN基薄膜表面晶格演变
6.
Measurement of Single Peak Distance and Contour Micro - plainness Distance;
表面粗糙度间距参数S_m与S测量方法的探讨
7.
The horizontally projected distance from the point of the star facet to the edge of the table, relative to the distance between the table edge and the girdle edge.
横排推算距离点的天星小面的边缘上表相对地之间的距离表边缘和肩带边缘.
8.
In character recognition, the distance between the undistorted surface of a document and a specified part of a printed character.
在字符识别中,文卷未变形表面与打印字符的指定部分之间的距离。
9.
On Extension of Isometries between Unit Spheres of c(Γ)-Spaces
c(Γ)型空间单位球面之间的等距延拓
10.
To grow or spread along a surface, rooting at intervals or clinging by means of suckers or tendrils.
蔓生间隔一段距离的根或通过吸根或卷须在物体表面上的生长或蔓延
11.
an ancient Roman unit of length (4.85 English feet) measured as the distance from the heel of one foot to the heel of the same foot when next it touches the ground.
古罗马长度单位（（待查表）英尺），测量同一只脚两次接触地面时脚后跟之间的距离。
12.
The distance between the nondeformed part of a document surface and a specified point on a printed character in optical character recognition.
浮雕效果在光学字元识别中，文件表面的未变形部分与印刷字元上特定点之间的距离
13.
measure the ground between two points
测量地面上两点间的距离.
14.
S There is a wide gulf between the rich and the poor in terms of water use.
在用水方面，贫、富之间有很大差距。
15.
Analysis on the space of circular micro-piles in plannar failure
微型圆桩加固平面滑坡的桩间距分析
16.
Application of RHEED in the Calculation of Al_2O_3 Interplanar Distance
RHEED在计算Al_2O_3晶面间距中的应用
17.
CELLSPACING Sets or retrieves the amount of space between cells in a table.
cellspacing设置或传递表格里的单元格间距。
18.
"The distance, in inches, between adjacent slots.
"边上的插槽之间用英尺表示的距离。