1.
Comparison of Beam-Column Element and Solid Element for Eccentric Structures
偏心结构空间杆系模型与空间实体模型的对比分析研究
2.
Analysis of Arch and Beam Combination Modeling Experiment of 56m Tied Arch Bridge;
56m系杆拱桥拱梁结合部静力模型试验分析
3.
Establishment Mathematical Models between Heat Treatment Parameter and Mechanical Properties of High-strength Drilling Pipe
高强钻杆管性能与热处理参数关系模型的建立
4.
The System Efficiency Plate Model of Progressive Cavity Pumping Wells
地面驱动螺杆泵井系统效率控制图模型研究
5.
Analysis for Dynamic Characteristics of the Sucker-rod Pumping System Based on LuGre Friction Model
基于LuGre摩擦模型的有杆抽油系统动态特性分析
6.
Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads
均布荷载下深梁设计的压杆-拉杆模型
7.
A MATHEMATICAL MODEL FOR PREDICTION AND DIAGNOSIS OF THE BEHAVIOR SUCKER ROD PUMPING SYSTEM IN DIRECTIONAL AND HORIZONTAL WELLS
定向水平井有杆泵抽油系统动态参数诊断和预测的数学模型
8.
Static Load Experimental Investigation to Model of Long Span Continuous Steel Truss Tied Arch Bridge;
大跨径连续钢桁系杆拱桥静力模型实验技术研究
9.
Pre-stress Loss Static & Dynamic Analysis of a Concrete Filled Steel Tube Tied Arch Bridge Model
钢管混凝土系杆拱桥模型的预应力损失静动力分析
10.
Research on the Control Model of Crank Servo Press & its Corresponding System Implementation
曲柄连杆伺服压力机控制模型的研究及系统实现
11.
Injection mould for plastic large-size mould bases-Return pins
GB/T12555.13-1990塑料注射模大型模架复位杆
12.
Design of Reinforced Concrete Deep Beam Based on Strut-and-tie Model;
钢筋混凝土深梁基于压杆—拉杆模型的设计
13.
Analysys and Computational Simulation on the Model of the Maillefer Zone of Maillefer-Screw;
分离型螺杆分离段模型分析及计算机数值模拟
14.
Strut-and-tie model method for design of reinforced concrete structures:Part Ⅰ model development
混凝土结构设计的拉-压杆模型方法——Ⅰ:模型建立
15.
Experimental Model and Simulation Analysis on Drill Pipe of the Reconnaissance Drilling;
勘查钻进钻杆的实验模型与仿真分析
16.
Apply Research of the Theory of Wholly Grouted Anchor Load Transfer Model;
全长粘结式锚杆传力模型及应用研究
17.
The Leverage Effect in Chinese Stock Markets Based on EGARCH Model;
基于EGARCH模型的我国股市杠杆效应研究
18.
A Benchmarking-based Evaluation-Motivation Model for Organizational Informationization;
基于标杆的组织信息化评价—激励模型