1.
Improvement of the orifice discharge coefficient may not result in stability improvement as illustrated in one test series.
由一系列的试验说明，喷孔流量系数的改善并没有导致稳定性的改进。
2.
diameter and number of hole
喷嘴量孔孔径及数目
3.
CFD Calculation of the Two-Phase Flow inside K-Factor Injection Nozzle
K系数喷油嘴喷孔内气液两相流动的三维模拟
4.
Research on Servo Valve Nozzle Eyelet Flow Character Measurement System;
伺服阀喷嘴小孔流量特性测量系统的研制
5.
Three Dimensional Numerical Simulation of Flow Characteristic in Ultra-multi Hole Injector
超多喷孔喷油嘴流动特性的三维数值模拟
6.
The operation principle of a automatic flow-rate detecting system of fuel injector is introduced and the design of hardware and software is presented.
介绍了喷油嘴四喷孔流量自动检测系统的工作原理，给出了系统硬件和软件设计。
7.
The influence of flow coefficient changes on ZH1105 diesel engine is studied in this paper.
研究了喷油嘴流量系数变化对单缸直喷柴油机性能的影响。
8.
Experiments of discharge coefficient of film cooling holes under adverse pressure gradient
主流逆压力梯度下气膜孔流量系数的实验
9.
Experimental investigation on discharge coefficient of jet impingement holes within semi-confined channel
半封闭通道射流冲击孔流量系数的实验
10.
Numerical studies about the discharge coefficient of film cooling hole at narrow space
狭小空间内气膜孔流量系数的数值模拟
11.
A Method for Calculating the Effective Vectoring Angle and Flow Coefficient of an Axisymmetric Thrust-Vectoring Nozzle
轴对称矢量喷管气动矢量角和流量系数计算方法研究
12.
Influence of angles and hole pitches on discharge coefficients of expanded holes at inlet and outlet
角度和孔间距对双向扩张型孔流量系数影响的实验
13.
Usually the number of holes in the spinneret determines the number of filament in the yarn.
一般喷丝头细孔的数量决定了纱中长丝的根数。
14.
Mathematical Model of Velocity Distribution in Flow Field of Multijet for Large Scale Oxygen Lance
大型多孔氧枪喷头射流速度分布的数学模型
15.
Approximate Calculation of Relationship between Discharge and Seepage Coefficient in Pressurized-water Test of Cut-off Wall
防渗墙钻孔压水流量与渗透系数关系的近似计算
16.
Derivation and experiments for jet nozzles′ coefficients of self-priming irrigation pump
射流自吸喷灌泵喷嘴系数的理论推导与试验
17.
Ouantitatively Calculating Method of Rheological Parameters of Jet Drilling Mud
喷射钻井泥浆流变参数定量计算方法
18.
" Measurement of fluid flow by means of orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full"
GB/T2624-1993流量测量节流装置用孔板、喷嘴和文丘里管测量充满圆管的流体流量