1.
The design of the new type outside fall lift spring safety valve
火车槽罐用外置全启式弹簧安全阀的设计
2.
Remove the relief valve cover, stem/diaphragm assembly, and relief valve spring.
拆卸安全阀阀盖，阀杆/隔膜总成，和安全阀弹簧。
3.
The relief valve spring will be free inside the body at this point.
这时安全阀弹簧将在阀体自由活动。
4.
Spring loaded safety valves
GB/T12243-1989弹簧直接载荷式安全阀
5.
Failure Analysis of the Elastic Spring of the Safety Valve of a Liquefied Oil Gas Storage Tank
液化石油气罐车安全阀弹簧失效分析
6.
Due to the release of pressure when removing the cover, the relief valve spring may eject quickly.
因为在拆卸阀盖时松开压力，安全阀弹簧可能会快速弹出来。
7.
Chatter and the solution of the direct spring loaded safety valve used for nuclear power plant
核电站用弹簧式安全阀的颤震现象及解决方案
8.
The relief valve cover shall be secured with stainless steel bolts and shall utilize a quarter-turn locking joint to capture the spring load of the relief valve.
安全阀阀盖应该采用不锈钢螺栓紧固，应该采用四分之一转锁定连接来所定安全阀的弹簧负载。
9.
Analyzes the cause of full open safety valve spring break built in liquefied petroleum gas railway tanker and describes the method for prevention of spring break.
分析了液化石油气铁路罐车内置全启式安全阀弹簧断裂的原因,介绍了防止弹簧断裂的方法。
10.
Remove the piston and spring from the relief valve housing and thoroughly clean all parts including the diaphragm.
从安全阀外壳上拆卸活塞和弹簧，彻底清洗包括隔膜的所有部件。
11.
Maintenance and Fault Clearance of Spring-loaded Safety Valve In Aluminum Oxide Production Process
氧化铝生产过程中弹簧式安全阀的维护及故障排除
12.
Remove valve spring and retainer.
拆卸阀弹簧和扣件。
13.
hydraulic relay valve return spring
液压式继动阀回动弹簧
14.
spring-loaded regulator
弹簧型自力式调节阀
15.
The Safety Role of the Spring Lock Washers in the Transmission & Distribution Line
弹簧垫圈在输配电线路中的安全作用
16.
The lower stem is encased in a spring which forces the stem away from the seat when the valve is opened.
下阀杆包裹在一个弹簧内部，当阀门开启时，弹簧迫使阀杆离开阀座。
17.
To avoid this discharge, install a spring-loaded, rubber seated check valve ahead of the backflow assembly.
为了避免这种排放，要在防回流阀总成前面安装一个弹簧驱动、橡胶阀座的止回阀。
18.
Preferred position for 2300 valves is in a horizontal line with spring chamber up.
对于系列2300阀门，首选的安装位置是在水平管线上，其弹簧隔膜朝上。