1.
governor mechanism
调速器机构，调节机构
2.
rack fuel control mechanism
齿杆式油量调节机构
3.
The non-bleed controller uses air only when exhausting the line to the controlled device.
无放流式调节器只有在通至调节机构的管道排气时才消耗空气。
4.
Design and Analysis of the Adjustive Mechanism of Pipe-line Robot for Variable Diameters
管道机器人自适应管径调节机构的研究与仿真
5.
Dynamics Simulation of Compressor’s Adjusting Mechanism Virtual Prototyping Based on UG&ADAMS
基于UG和ADAMS的调节机构虚拟样机动力学仿真
6.
Amblyopia Pro/E-based Regulatory Agencies to Achieve Centrometer Gear;
基于Pro/E的弱视仪瞳距齿轮调节机构的实现
7.
top link adjustment
(悬挂机构的) 上拉杆调节
8.
linkage control spring
悬挂机构力的调节弹簧
9.
Pneumatic valves regulate the pneumatic enforcement agencies and regulatory valves two.
气动调节阀由气动执行机构和调节阀两部组成。
10.
On the Formation of a New Type Regulatory Mechanism Based on Market Regulation with State Regulation as the Leading Factor
构建“以市场调节为基础、以国家调节为主导”的新型调节机制
11.
The regulating handle consists of manoeuvring valve pos. no.01 and handle mechanism.
调节手柄由操纵阀01和手柄机构组成。
12.
Outdoor unit covering structure of household central air conditioner and energy efficiency
户式集中空调室外机罩壳结构与节能
13.
Regulating valve actuator based on reversible step-by-step unit
可逆步进装置调节阀执行机构的研究
14.
Hydraulic Valve Lash Adjuster (HLA) and Valve Train with HLA
液压气门间隙调节器及有间隙调节器的气门机构的研究
15.
Detection Method for Jam Fault in Manipulative Mechanism of Steam Turbine Regulating System
汽轮机调节汽门操纵机构卡涩诊断方法
16.
Automatic yarn let-off system which used change gear drive for regulating run-in values.
采用交换齿轮调节送经量的积极式送经机构。
17.
Fabric take-up and batching mechanism, which used change gear drive for adjusting the fabric density.
采用交换轮调节织物密度的牵拉卷取机构。
18.
Design and Analysis of Cascade Regulator with Single Chip Microcomputer
采用单片微型机构成串级调节器的设计与分析