1.
Research on Non-contact Measurement Technology of Two Axes' Parallel Error for Crankshaft;
曲臂两臂轴线平行度误差非接触检测技术研究
2.
The Design and Research of Folding-Arm Aerial Cage's Hydraulic System
曲臂高空作业车液压系统的设计研究
3.
The Hydraulic System of 18m Bowed Boom Fire Extinguishing Treppeniteration Car
电液比例复合阀在18米曲臂云梯车上的应用
4.
Calculating Deformation of 65 Meter High Skylift Using Geometric Non-linear Method;
65米曲臂登高平台消防车变形的非线性分析
5.
flex one's stiff arm slowly
慢慢弯曲僵硬的手臂
6.
engine supporting arm
发动机曲轴箱支座臂
7.
To bend the arm at the elbow, the muscle at the front of the upper arm has to shorten and bunch up.
要从肘部弯曲手臂,就要收缩上臂正面的肌肉。
8.
The joint or bend of the arm between the forearm and the upper arm.
肘关节上臂与前臂之间的关节或胳膊弯曲处
9.
Standing at the back of the crowd, we wrapped our arms around each other, swaying to the music.
我们站在人群的后面,臂挽着臂,随着乐曲摆动着。
10.
Bending behaviors of functionally gradient piezoelectric curved cantilever was studied.
研究了弯曲型梯度功能压电悬臂梁的弯曲特性。
11.
The large muscle at the front of the upper arm that flexes the forearm.
位于上肢前面使前臂屈曲的大型肌肉。
12.
Study on Construction Control of Cantilever Erection Continuous Curved Girder Bridge;
悬臂拼装曲线连续梁桥施工控制研究
13.
The Spirit Source from the Trilogy Father to Brokeback Mountain;
从“父亲三部曲”到《断臂山》的精神源流
14.
Knocking therapy for flexure fracture of forearm
捶击法治疗外伤性前臂弯曲骨折12例
15.
Research on bending of the cantilever based on the principle of minimum potential energy
基于最小势能原理的悬臂梁弯曲研究
16.
BOUNDARY INTEGRAL FORMULA FOR BENDING OF CLAMPED SEMI-INFINITE PLATE
悬臂半无限大板弯曲的边界积分公式
17.
After this little incident, I went over and just put my arms around him and hugged him.
这一小插曲之后,我走过去伸出手臂拥抱了他。
18.
All feet first entries shall be executed with the arms close to the Body and no bending at the elbows.
脚先入水时,两臂应紧贴身体两侧,手肘不能弯曲。