1.
Study of the Metallographic Quantitative Analysis on Fire Copper Wire
火灾中铜导线熔痕金相组织定量研究
2.
Thin wires easily melt if they are made of copper.
如果用铜制细导线极易熔化。
3.
Microstucture Characteristics and Key Factors Study of Cracks in Copper Wires
铜导线断裂痕迹显微组织特征及成因研究
4.
REMOVE AND INSPECT FUSE #7
移走并检查＃熔线。
5.
REMOVE AND INSPECT FUSE #:
拆掉并检查熔线＃。
6.
TO PDC "ABS PUMP" FUSE
ＰＤＣ＂ＡＢＳ油泵＂熔线
7.
PUMP/MOTOR FUSE (ABS PUMP)
泵／马达熔线（ＡＢＳ泵）
8.
CAE Study on the Effects of the Wall Thickness of the Lens on Automobile Lamp on the Weldline;
车灯面罩壁厚对熔接痕影响的CAE研究
9.
Analysis on the Causes of the Seams on Injection Plastics;
注射塑料制品产生熔接痕的原因分析
10.
Study and application of high-gloss & no-weldline steam injection molding technology
蒸汽高光无熔痕成型技术研究与应用
11.
NEW TECHNOLOGY FOR MODEL PREDICTION AND IMPROVEMENT OF WELD LINE STRENGTH IN INJECTION-MOLDED PARTS
注塑件熔接痕强度预测及提高新技术
12.
The Study on the Ignition Capability of Aluminium Wire Circuit Melted Bead for Common Solid Combustible
铝导线短路熔珠对固体可燃物引燃能力实验研究
13.
Study on Forming Mechanism and Eliminating Methods of Weld Line on Injection Molding Parts;
注塑件熔接痕形成机理与消除方法的研究
14.
Research on Removing Fusion Line with Hot Runner Multi-gates Sequence Control;
热流道多浇口顺序控制消除熔接痕的研究
15.
Studies on Improving Weld Lines in Molded Parts by Exploiting Sequential Injection Molding
热流道顺序注塑成型工艺改善制品熔接痕研究
16.
Fault Analysis and Optimization of Weld Line in Injection Molding Parts Based on Moldflow
基于Moldflow的注塑件熔接痕缺陷分析与优化
17.
Application of Rough Set Theory in the Analysis of Weld Line on Injection Molding Parts
粗糙集理论在注塑件熔接痕分析中的应用
18.
Weld-line Control and Analysis on the Injection Molded of Digital Camera Panel
数码相机面板注塑成型熔接痕控制分析