1.
Research on Lubricating Oil Temperature Control Strategy of Gears in Drive-axle in Fatigue Testing System of Gears in Drive-axle Assembly of Vehicile
车辆驱动桥总成齿轮疲劳试验台中驱动桥齿轮润滑油油温控制策略的研究
2.
Calculations of Load in Transmission System and Design of Driving Axle Parameters for Hong Qi Limousines
红旗牌汽车传动系负荷的计算和驱动桥齿轮设计参数的选择
3.
Assembly Method of Spiral Bevel Pinion in a New Type of Drive Axle
新型驱动桥主动螺旋伞齿轮的装配方法
4.
Hyperbolic gear oil is recommended to be used in the differential gears in driving axles.
汽车驱动桥的差速器齿轮应采用双曲线齿轮油来润滑。
5.
Research and Development on Fatigue Testing System of Gears in Drive-axle Assembly of Automobile;
汽车驱动桥总成齿轮疲劳测试系统的研发
6.
The Analysis of High-Speed Main Drive Axle Hypoid Reducer Gear
高速驱动桥主减速器准双曲面齿轮特性分析
7.
Worn teeth on ring gear or drive pinion gear.
环形齿轮或驱动小齿轮上齿磨损。
8.
intermediate axle bevel gear and pinion
中桥主动及被动伞齿轮
9.
rear axle bevel gear and pinion set
后桥主动及被动伞齿轮
10.
twin-geared press
双边齿轮驱动压力机
11.
End play in drive pinion bearings.
驱动小齿轮轴承的端隙。
12.
Analysis of Gasket-selection for Driving Taper Assembly of Automobile s Driving Axle and the System Development;
汽车驱动桥主动锥齿轮总成选垫分析及系统实现
13.
rear axle bevel pinion flange
后桥主动伞齿轮法兰
14.
Research and Development on Fatigue Testing System of Gears in Drive-axle Assembly of Heavy-duty Trucks;
重型车辆驱动桥总成齿轮疲劳测试系统的研究与开发
15.
Fault diagnosis and trend analysis of power-train axle shell for vehilce
汽车驱动桥台架试验的齿轮早期失效诊断与趋势分析
16.
Excessive distance between pinion gear and flywheel/drive plate gear.
小齿轮和飞轮/驱动板齿轮之间距离过大。
17.
Refer to Drive Pinion Bearing Pre-Load Adjustment.
参阅驱动小齿轮轴承预荷调整。
18.
The ring gear (bolted to the differential case) rotates the case
环形齿轮（栓在差速箱上）驱动差速箱