1.
Interaction between Girder and Rail of Rail Transit Viaduct with U-shape Girder;
轨道交通槽型梁桥梁轨相互作用研究
2.
The Application of Pre-stress Concrete U-Shaped Beam in Road-Bridges;
预应力混凝土槽型梁在公路桥梁中的应用
3.
Erection construction technology of the 46m beam channel spanning Jing-Hu railway
46m槽型梁跨京沪铁路架设施工技术
4.
The calculation method study of prestressed concrete cell type beam
预应力混凝土槽型梁的计算方法研究
5.
Study on Ultimate Bearing Capacity and Optimum Design of Prestressed RPC Channel Girders;
预应力RPC槽型梁的极限承载力及优化设计研究
6.
This bridge was built with precast channel girder sections, but could be built with AASHTOI girders or box sections.
该桥是采用预制的槽型梁修建的，但是也可利用AASHTOI的标准工型梁或箱型梁修建。
7.
Construction of fish-bellied large volume continuous box girder groove
大体积鱼腹式槽型连续箱梁施工技术
8.
Finite Segment Method for Wide-flange Beam Considering Both Shear Lag and Shear Deformation
槽型宽翼梁剪滞效应分析的有限段法
9.
Researches and developes a new technique in making the U-Shape groove (include board of flank) in the main girder of the LD electric single-girder grane by cold bending;
LD型电动单梁起重机主梁U型槽(侧板)冷弯成型工艺的研究与开发
10.
Study on Improved Pseudo-three-dimensional Fluid Structure Interaction model of Beam Aqueduct Structures
梁式渡槽“改进拟三维”流固耦合模型研究
11.
Modeling and Simulation of a Constrained Damping Beam with Slotted Stand-off Layer
新型带槽扩展层约束阻尼梁结构的建模与仿真
12.
Analysis of two-time prestressing construction of aqueduct with large wall-beams
大型墙梁式渡槽二次预应力施工过程分析研究
13.
During fabrication slots for the stringers flanges were flame cut into box girders.
制造时，为安装纵梁翼缘，在箱型梁中用焰割法开槽口。
14.
Study on the Beam-Shell FSI Dynamic Model and Its Engineering Applications of Large Aqueduct
大型渡槽梁壳流固耦合动力模型及其工程应用研究
15.
Research on the Longitudinal Seismic Simulation Effects of the Pseudo 3D FSI Model of Beam Aqueduct
梁式渡槽“拟三维”流固耦合模型的纵向地震模拟效果分析(英文)
16.
Transfer Matrix Method for Shear Lag Analysis of Cable-stayed Bridge with Double Cable Plane and Wide-flange Beam
双索面槽型宽翼主梁斜拉桥剪力滞效应分析的传递矩阵法
17.
Application of Prestressed Continuous Groove Beams in a Road Bridge
预应力连续槽形梁在公路桥梁中的应用
18.
Base structure side crossbearm adds compcting cylinder. (opening aperture of the fork lift packet).
底架侧梁增加压紧汽缸（叉槽开口处）。