1.
observed mean failure rate
平均故障率的观察值
2.
Study on MTBF Assurance Test Risks
平均故障间隔时间保证试验风险研究
3.
Research on distribution model of WEDM mean time between failures
电火花线切割机床平均故障间隔时间分布模型的研究
4.
mean time between forced outage
故障停用平均间隔时间
5.
mean time between defects
故障平均间隔时间欠缺之间平均时间
6.
mean time before failure
故障前平均时间修理间隔平均时间
7.
Given the failure rates for given subsystems, the Six Sigma Black Belt will be able to use reliability apportionment to set mtbf goals.
给出给定子系统的故障率，6西格玛黑带应能利用可靠性分配原则设定平均无故障时间目标。
8.
Furthermore, it forecasts the firing cycles of non-failure when other firing conditions are normal.
进而预测在其它射击条件正常情况下,火炮平均无故障射弹发数。
9.
Research on earlier fault diagnosis of gear by method of multi-resolution empirical mode decomposition and frequency domain averaging
多分辨EMD方法与频域平均在齿轮早期故障诊断中的研究
10.
mean time between scram
事故停堆平均间隔时间
11.
acceptable malfunction level
容许故障等级;容许故障水平;容许事故等级
12.
A Nomograph Algorithm of Fault Section Diagnosis and Loads Equalization for Distribution Networks;
配电网故障定位和负荷均衡的图算法
13.
A Fault Diagnosis Approach for Rolling Bearings Based on Time Series Decomposition and Blind-Equalization
基于盲均衡理论的轴承故障诊断研究
14.
The Six Sigma Black Belt will be able to compute basic reliability statistics (mtbf, availability, etc.
译文：六西格玛黑带应该能够计算基础的可靠性统计（平均无故障时间、有效性等）。
15.
Notebook Computer Quality Improvement Study Based on DOA and MTBF
基于一次开箱不合格和平均无故障时间指标的笔记本电脑质量改进研究
16.
IMPORTANT: Inspection and service should also be performed anytime a malfunction is observed or suspecte
重要：出现任何故障或怀疑有故障时，均应进行检视和维修。
17.
having more than the average number of accidents.
发生事故的数量比平均数量高。
18.
Rolling Bearing Fault Diagnosis Based on EMD and Fuzzy C Means Clustering
基于EMD和模糊C均值聚类的滚动轴承故障诊断