1.
The process could not set failover mode to 'queued'.
进程未能将故障切换模式设置为“排队”。
2.
The process could not set failover mode to 'immediate'.
进程未能将故障切换模式设置为“即时”。
3.
The failover mode was successfully set to 'immediate'.
成功将故障切换模式设置为“即时”。
4.
AVAILABILITY ANALYSIS AND FAILURE HANDOFF METHOD FOR TELEPHONE SERVER BASED ON SIP
基于SIP的电话服务器故障切换方法与可用性分析
5.
Fault Causes Analysis of Fast Switch on-load Test of Unsuccessful Causation with Fast Switch Device
厂用电切换装置带负荷切换实验故障原因分析
6.
Disposal of No Switchover Trouble for Transfer Case of Truck-mounted Concrete Pump
混凝土泵车分动箱不切换故障的处理
7.
Analysis on A Particular Low Handover Failure of Softswitch Interoffice
一种特殊的软交换局间低切换成功率故障分析
8.
The following fault conditions can cause an RCS to quick failover:
下列的故障情况会引起 RCS 的快速失败切换：
9.
Fault detection for networked control system based on switched system
基于切换系统的网络化控制系统的故障检测
10.
Fault Identification and Power Value Design for an Equipment for Instantaneous and Disturb-Free Automatic-Switch of Double Power;
准瞬间无扰动双电源自动切换装置故障识别及功率阀设计
11.
Analysis and Treatment a Fault of Voltage Switch Circuit with Self Retaining Winding
一起带自保持线圈的电压切换回路故障分析及处理
12.
Fault analysis and lines improvement of the automatic on-off change-over of pump sets for UMS
无人机舱泵组频繁自动切换的故障分析及线路改进
13.
Troubleshooting of Paper Rate Transition for ECG-6511
ECG-6511纸速转换故障分析
14.
The Approach About the Cutting Torch Cuts Slab Regularly after Ethernet Has Trouble
H1网故障切割机正常切割板坯的研究
15.
Select YES to replace failing printheads.
选择“是”更换存在故障的打印头。
16.
REPLACE THE DEFECTIVE DOOR LOCK SWITC
更换存在故障的门锁开关。＊
17.
The Fault Diagnosing System Develepment for user SPC Switching System
用户程控交换机故障诊断系统的研制
18.
Research on Condition Monitoring and Fault Diagnosis of Heat Exchangers for Power Plant;
电站热交换器的监测与故障诊断研究