1.
Creating automatically of tolerance entity of axis or hole based on VBA and ADO
基于VBA及ADO技术的轴、孔公差自动标注
2.
" Tolerance and fitting, dimensions up to 500mm holes, shaft tolerance range and fitting"
GB/T1801-1979公差与配合尺寸至500mm孔、轴公差带与配合
3.
" Tolerance and fitting, dimensions up to 18mm holes, shaft tolerance range"
GB/T1803-1979公差与配合尺寸至18mm孔、轴公差带
4.
" Tolerance and fitting, dimensions larger than 500mm and up to 3150mm ordinary holes,shaft tolerance range"
GB/T1802-1979公差与配合尺寸大于500至3150mm常用孔、轴公差带
5.
Application of Inter-hole Millisecond Order Detonation Technology in Lunan Mining Company
孔间微差顺序起爆技术在鲁南矿业公司的应用
6.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面，定位销，夹紧顺序，孔位测量销，模拟块偏置值及公差需有标识。
7.
Influences of Porosity Error on Electrical Properties of Rock and Updating Formula as Well as Correction Charts
孔隙度误差对岩电参数的影响及校正公式和图版
8.
Analysis of the Cylindricity Tolerance and Press Mounting Curves of Axle Wheel Seat and Wheel Hub Bore
关于车轴轮座、车轮轮毂孔的圆柱度公差和压装曲线分析
9.
Relationship between Finishing Groove Design and Negative Allowance Control of Hot Rolled Ribbed Steel Bars
热轧带肋钢筋负公差控制与成品孔槽设计的关系
10.
An allowed difference in dimension of closely mating machine parts.
公差，容差机器配件的公差，容差
11.
Co-Phasing Error Study of the Sub-apertures' for Optical Sparse Aperture System
光学稀疏孔径成像系统子孔径位相误差研究
12.
A Brief Analysis of Compensation on Dimension Tolerance and Shape and Position Tolerance in Tolerance Principle;
公差原则中形位公差与尺寸公差的补偿简析
13.
remedy allowance,common difference;tolerance
公差(数学、机械)
14.
Hunter lab colour difference equation
亨特Lab色差公式
15.
Tolerancing principle
GB/T4249-1996公差原则
16.
Confucius died of illness in 497 BC.
孔子于公元前479年病逝。
17.
Peacock Princess
中国民间故事：孔雀公主
18.
Unbonded elastic wire resistance type pore pressure cell
GB/T3411-1994差动电阻式孔隙压力计