1.
Calculating method for strength of steel pipe flanged joint
GB/T17186-1997钢制管法兰连接强度计算方法
2.
Discussions on joint studs(thread)intensity calculation for body and bonnet
阀体与阀盖连接螺柱(螺纹)强度计算方法的探讨
3.
Ultimate capacity of unstiffened cover-slab of tubular structure using in the supporting joint
圆钢管销铰连接中端板的受力性能和强度计算
4.
Calculation and test of intensity and strength for Joint airproof structure at Front and back junction of Fiber wraped shell structure
纤维缠绕壳体前后接头连接密封结构强度和刚度计算与试验
5.
Calculation method of initial stiffness for reinforced panel zones in beam-to-column connections
加强式梁柱连接节点域初始刚度的计算方法研究
6.
A method for calculating the motion angle of linkages using magnetometers and accelerators
应用磁强计和加速度计的连杆运动角度计算
7.
Intensity Analysis and Calculation of the Principle Shaft System Parts of Continuous Extrusion Machine;
连续挤压机主轴部件强度分析与计算
8.
Calculation of the High Temperature Distribution on the SiC/Fe/SiC Joint
SiC/Fe/SiC连接件高温温度场分布的计算
9.
Direct Calculation of Bulk Carrier Structure Strength and Research of Strength Criterion;
散货船结构强度直接计算及强度标准研究
10.
Direct Calculation of Structural Strength and Optimization Design Based on Engineering Ship;
工程船结构强度直接计算及优化研究
11.
Research for Direct Calculation of Bulk Carrier's Structural Strength Based on Common Structural Rules
基于CSR散货船结构强度直接计算研究
12.
Direct Calculation of Transverse Strength for 100m Deck Cargo Ship
100m甲板货船的横向强度直接计算
13.
Code for design,construction and acceptance of high strength bolt connection of steel structures
钢结构高强度螺栓连接设计施工及验收规范
14.
Calculation of the back-ring structure around bulkhead in submarine considering contact
潜艇舱壁支撑环计及接触时的强度计算
15.
Effective Length Factor of Columns in Two Web and Top-seat Angle Semi-rigid Connected Steel Frames;
四角钢半刚性连接刚架柱计算长度系数
16.
Analysis on effective length of column in semi-rigid jointed steel frames with lateral displacements;
有侧移半刚性连接钢框架柱计算长度的研究
17.
Effective Length Factor of Column in Sway Steel Frames with Reduced Beam Section Connections
狗骨式节点连接的钢框架柱计算长度系数
18.
Calculation of initial stiffness and ultimate bearing capacity of top-and-seat angle connections
顶底角钢连接的初始刚度和极限承载力计算