1.
The cold drawing wire prestressed concrete slab with circle hole is widely usedas a structure member.
冷拔钢丝预应力圆孔板是广泛使用的结构构件.
2.
AXIAL COMPRESSIVE TEST AND ANALYSIS OF PREFABRICATED HOLLOW SHEAR WALLS
预制圆孔板剪力墙轴心抗压试验与分析
3.
The Study on the Stress Concentration Coefficient of the Composite Laminates with a Circle Hole;
带圆孔复合材料层合板应力集中系数的研究
4.
Study on Structure of Large Diameter Prestressing Allied Circular Inverted Siphon;
大孔径预应力连体式圆形倒虹吸结构研究
5.
Design and analysis of new double-hole asymmetric prestressed reinforcement slab
双孔预应力非对称无砟轨道板设计与分析
6.
In the study, an infinite plate with elliptic notch is subject to remote stresses at infinity.
在分析中，设带椭圆孔口的无限平板受远处应力作用。
7.
Stress of composite material plate with circular hole was analyzed by the model above.
按照所建立的计算模型对含有圆形孔的复合材料板进行应力分析。
8.
The aim of this study is to explore the concentrating effects of both the electric current density and the stresses in the plate due to the existence of the elliptic hole.
其研究重心是定量计算椭圆孔对电流密度以及板内应力分布在椭圆长轴端点处的集中效应。
9.
Study on Secondary Moment and Redistribution of Internal Force about Continus Prestressing Concrete Hollow-core Slabs with Cold-drawn Low Carbon Wires
冷拔丝预应力砼连续多孔板的次弯矩及内力重分布研究
10.
superimposed floor slab with prestressed concrete thin plate
预应力薄板叠合楼板
11.
Stress distribution near the opening and stress concentration for composite laminates with a circular opening
含孔复合材料层合板孔边的应力集中
12.
Round and square perforation plate screens-Thickness of 3 mm and above
GB/T10613-1989板厚≥3mm的圆孔和方孔筛板
13.
quadrant-edge orifice plate
1/4圆周边缘孔板
14.
Seismic response analysis and test verification of perforated composite steel plate wall structures
钢板开圆孔的组合钢板墙结构地震反应分析与试验验证
15.
CALCULATION ON HOLE-EDGE STRESS OF COMPOSITE MATERIAL PLATE WITH HEXAGON HOLES
带有六边形孔的复合材料板之孔边应力计算
16.
Approximate Calculation of Stress Distribution Near Hole for Composite Laminates with Finite Width
含孔复合材料层合板孔边应力集中的近似计算
17.
The Analysis of Stress Concentration Based on ANSYS;
基于ANSYS的有限宽板孔边应力集中分析
18.
Application of fluid dynamics software in orifice flow measurement
流体动力学软件在孔板测量中的应用