1.
Study on Dynamics of Vehicle with Independently Rotating Wheel of Non-Common Axle;
无公用轴独立旋转车轮车辆动力学研究
2.
CAI bearings are of motor class bearings and the common tolerance is shown on the attached data sheet.
CAI轴承一般为电机级轴承，最常用的轴承公差精度见附表所示。
3.
The unified formula results from the revolution and translational movement of the coordinate axis.
利用坐标轴的旋转和平移,导出了组合机床主轴箱多种传动形式下传动轴坐标计算的统一公式。
4.
Research and Application on Load Planning of Hub-and-spoke Network for Road Express;
公路快速货运轴辐式网络运载规划研究与应用
5.
Theoretical Inference and Experiential Formulas of Mandrel Diameter Applied to Wind Garter Spring;
绕制卡簧用心轴直径的理论推导与经验公式
6.
Some Reasonable Converted Formulas of The Often-used One of Coaxial Cable's Attenuation Quotient in Engineering Designs
对同轴电缆衰减系数工程上常用公式的改进
7.
crankshaft journal milling machine
曲轴轴颈铣削专用机床
8.
A shaft that turns or is turned by a crank.
机轴用曲柄来转动的轴
9.
" Tolerance and fitting, dimensions larger than 500mm and up to 3150mm ordinary holes,shaft tolerance range"
GB/T1802-1979公差与配合尺寸大于500至3150mm常用孔、轴公差带
10.
The transmission principle and dynamic analysis of the inner planetary gear reducer with three axies are described in this paper.
本文论述了三轴式内齿行星减速器的传动原理、力学分析，推导出转臂轴承作用力的计算公式。
11.
A formula for accurate calculation of the influence of insulation eccentricity on the coaxial capacitance, characteristics impedance and insulation resistance of RF coaxial cables were deduced by the electrical axis method.
本文利用电轴法推导出精确计算绝缘偏心时同轴电容、性阻抗和绝缘电阻的计算公式。
12.
Rolling bearings--Thrust ball bearings--Tolerances
GB/T307.4-1994滚动轴承推力球轴承公差
13.
Rolling bearings--Needle roller bearings-Track rollers--Tolerances
GB/T6445.2-1996滚动轴承滚轮滚针轴承公差
14.
General Expression of Cutter's Axial Section for Machining Helicoids and Its Numerical Solution
计算螺旋面刀具轴截形的通用公式和计算机数值解法
15.
Application and Research of the Value Stream at JDS Plant;
价值流分析在吉林北方捷凯传动轴公司的应用与研究
16.
A practical formula to calculate the cutoff wavelength of square and rectangular coaxial lines
一种方形及矩形同轴线截止波长的实用计算公式
17.
High quality bearing steel is selected to prolong the beering's service life.
轴承选用精制轴承钢，使用寿命长。
18.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。