1.
Analysis of Crankshaft Bearing Lubrication Based on ADAMS-ENGINE
基于ADAMS-ENGINE的曲轴轴承润滑分析
2.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
3.
Elastohydrodynamic Lubrication Analysis of Crankshaft Bearing Considering Crankshaft Deformation under Load and Roughness Surface;
计入曲轴受载变形的粗糙表面曲轴轴承弹性流体动力润滑分析
4.
Thermohydrodynamic Lubrication Analysis of Crankshaft Bearing Considering Crankshaft Deformation under Load;
计及曲轴受载变形的曲轴轴承热弹性流体动力润滑分析
5.
Elastohydrodynamic Lubrication Analysis of Crankshaft Bearing Considering Crankshaft Deformation and Block Distortion
计及曲轴和机体变形的曲轴轴承弹性流体动力润滑分析
6.
Design and Simulation of Fracture Splitting Machine Tool for Bearing Bracket of Engine Crankcase
发动机缸体曲轴轴承座裂解机床设计及仿真
7.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
8.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
9.
Crankshaft and main bearings service
曲轴和主轴承的维修
10.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
11.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
12.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
13.
Dynamic Method to Calculate for Shaft Center Trajectory of Bearing of Internal Combustion Engine
求解内燃机曲轴—轴承轴心轨迹的动力学方法
14.
MAIN BEARING JOURNAL DIAMETER (CRANKSHAFT REMOVED)
主轴承颈部直径（曲轴已卸去）
15.
Optimization Design of Bearing for Internal Combustion Engine Considering Crankshaft Strength;
计及曲轴强度的内燃机轴承优化设计
16.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
17.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
18.
Coupling Analysis of Dynamics Tribology and Elastic Mechanics for a Crankshaft Bearing System
计入曲轴倾斜时曲轴-轴承系统动力学摩擦学和弹性力学耦合分析