1.
Study on the Strength of the R2 Reversible Mill's Main Drive System;
R2可逆式轧机主传动系统强度分析
2.
Study on Improvement of the Main Transmission System in 2800 Rough Mill;
2800热粗轧机主传动系统改造方案研究
3.
Study on Strength and Self-excitation in the Main Driving System of the Rolling Mill;
轧机主传动系统的强度及自激振动研究
4.
Non-linear twist vibration of main transmission system of vertical rolling mill
立辊轧机主传动系统的扭振非线性分析
5.
Nonlinear Twist Vibration of Main Transmission System of Vertical Medium Plate Mill
中厚板立辊轧机主传动系统的非线性扭振
6.
Remote monitoring and fault diagnosis system for main drive system of rolling mill based on technology
基于OPC技术的轧机主传动系统远程监测与诊断
7.
Fault Diagnosis for the R4 Main Transmission System sMain Angular gear seat of the Hot Strip Mill;
R4轧机主传动系统齿轮座及其基础振动的故障诊断
8.
Parameterized modeling and motion simulation of gears in mill's main transmission system
轧机主传动系统齿轮的参数化建模及运动仿真研究
9.
Application of IEGT three-level converter in the main driving system of thick plate mill
IEGT三电平变频器在厚板轧机主传动系统中的应用
10.
APPLICATION OF SIMATIC FM458 IN MASTER DRIVE AUTOMATION SYSTEM OF FQM
SIMATIC FM458在FQM连轧管机主传动自动控制系统的应用
11.
Research on the Torsional Vibration and Dynamic Strength Check of Stand F2 of 1580 PC Rolling Mill Drive;
1580PC轧机F2机座主传动系统扭振研究和动态强度校核
12.
The On-line Monitoring and Analysis System Based on Fieldbus for Hot Strip Rolling Set's Primary Transmission System;
基于现场总线的热轧机组主传动系统在线监测分析系统的研制
13.
Vibration Research of Transmission system for Vertical Ring Rolling Mill
立式轧环机传动系统的振动分析研究
14.
Application of CROWBAR in AC frequency converter drive system for rolling mill
轧机交流变频传动系统中CROWBAR的应用
15.
Character of AC-AC Frequency Converter Control System of Main Driving on Medium-heavy Plate in Bayi Steel
八钢中厚板轧机交—交变频主传动控制系统的特点
16.
A fully digital electric control system based on the Profibus-network-structure for the main drive of the medium plate mill
基于PROFIBUS网络结构的全数字中板轧机主传动电控系统
17.
Computer system in continuous bar and section rolling and control technique for main drive of rolling mill used abroad at present aresummarized, and their further developing trend stated as well.
介绍了当今国际上棒材、材连轧中所采用的计算机系统和轧机主传动的控制技术及其发展趋势。
18.
Automization Improvement on Electrified Transmission Control System of 1 200 mm Cold Rolling Mill
1200mm冷轧机列电气传动控制系统自动化技术改造