1.
Design of Programmable Voltage Source System Based on FPGA
基于FPGA的可编程电压源系统设计
2.
Study on Programmable Voltage Quality Disturbances Generating Device
可编程电压质量扰动发生装置的研究
3.
controller programmable, electrical, for a voltage not exceeding 1000v
电可编程序控制器不超过1000v电压用
4.
Direct control of electro-hydraulic stepping cylinder by the use of PLC
电液步进液压缸的可编程控制器直接控制
5.
Application of Programmable Logic Controller in Metro Industry
可编程控制器在地铁低压配电系统中的应用
6.
The automatic voltage regulator (AVR) is programmed to regulate the transmission bus voltage within a reselected tolerance, despite varying transmission conditions.
自动电压调节器(AVR)可在事先选定的容限范围内编程调节不同状态的输电母线电压。
7.
The input comparator in the circuit features a fairly wide range of common-mode voltage, and provides programmable hysteresis input and programmable input/ output delay.
输入比较器有较宽的共模电压范围，有可编程磁滞输入和可编程输入／出延时。
8.
The result shows that this device has low programming power, big programming window, low read voltage, small cross talk between bits.
研究结果表明该器件具有编程功耗低、编程窗口大、读取电压低、比特间串扰小等特点。
9.
Research on Insulation Fault Diagnosis Models for Power Transformers Based on Genetic Programming;
基于遗传编程的电力变压器绝缘故障诊断模型研究
10.
Research of Real-time ECG Signals Compression Methods Based on FPGA;
基于可编程逻辑器件的心电信号实时压缩方法研究
11.
Programmer: A person involved in writing a computer program.
程式编制员:参加编写电脑程式的人
12.
programmable electronic timer
可编程序的电子计时器
13.
mask programmable integration
掩模可编程序集成电路
14.
very apt at programming a computer
非常善于编电脑程序.
15.
The Simulation of Cutting-Extruding Process and the Programming of Visual;
切削—挤压成形过程仿真及可视化编程
16.
Flat paper feeding, automatic steamatic streamline process of binding, paper folding and flat-pressing; full set of imported electric appliances, PLC programmable, and imported nail binding head.
平纸进料，自动装订、折页，压平流水作业；全进口电器配置，PLC可编程；配进口订钉头。
17.
Description of compilation work of ‘SMEPC transformer whole course management code’ and key points for its implementation;
《上海市电力公司变压器类设备全过程管理规范》的编制说明及实施要点
18.
The application of S7-200 PLC to Cross-Wedge Rolling;
S7-200可编程器在板压机上的应用