1.
Minimum Tooth Number for Non-undercutting and Noncontact Area on Tooth Surface of A Worm Gear in Archimedes Worm Drive
阿基米德蜗杆传动蜗轮无根切最少齿数和齿面非接触区
2.
Accordingly,the least teeth number without undercutting is also decided only by the design pressure angle of the gear,without any relation to the coefficient of addendum height of the gear.
相应的无根切最少齿数也仅取决于正弦齿轮的设计压力角,而与齿顶高系数值无关.
3.
Research on the Modification Coefficient Calculation of Conical Involute Planetary Gear with Few Tooth Difference
变齿厚齿轮少齿差传动变位系数计算研究
4.
The Judgment Condition for the Involute Gear Pair with Fewer Teeth Number outside Pitch Point;
少齿数渐开线齿轮节点外啮合的判定条件
5.
Based on Pro/e about virtual modeling and simulation of few teeth gear
基于Pro/E的少齿数齿轮拟实造型与仿真研究
6.
The smallest amount possible or the most worthless thing.
最少数量，最无价值物品
7.
ANALYSIS AND STUDY OF COLD-PRESS HOLDING BUTTON OPTIMUM PARAMETERS OF BUTTON BIT
柱齿钻头冷压固齿最佳参数的分析与研究
8.
Study about the Optimum Value of External Spur Pump Gear and Its CAD;
外啮合齿轮泵的泵齿轮最佳参数的研究及CAD
9.
The research of denticle cylinder gear of avoiding the interference root taking place for slice
避免圆柱齿轮干涉及根切的最小齿数研究
10.
Brush at least twice a day with Glister Multi-Action Fluoride Toothpaste to help remove food residue and plaque.
每天以丽齿健?氟素牙膏刷牙最少两次，清除牙齿上的食物残渣！
11.
Computer-Aided Geometric Design and Parameters Optimization of Internal Gear Pairs with Small Teeth Difference;
少齿差内啮合齿轮的计算机辅助几何设计及参数优化
12.
MADE (Minimum Airborne Digital Equipment)
最少机载数字式仪表
13.
involute internal gear pair with small teeth difference
渐开线少齿差内齿轮副
14.
planetary gearing with small difference between the numbers of teeth
少齿差行星齿轮传动
15.
Too few elements in non-empty trimesh indices array (minimum 7)
非空三阶指数数组中的元素太少 (最少为 7)
16.
lowest wages; the least amount of fat allowed; the smallest amount.
最低工资；所允许的最少的油脂；最小的数量。
17.
Abstract: In this paper, the formula of calculation of the axial profile of an involute helical gear( or an involute helicoid worm) is inferred.
文摘:渐开线圆柱斜齿轮，当齿数很少而螺旋角很大时，可以看作渐开线圆柱蜗杆。
18.
small module taper shafted straight tooth slotting cutter
小模数锥柄插齿直齿刀