1.
Thin-walled Tube with Small Radius and Internal Medium Pressure Forming Technique
薄壁小半径弯管与中压内胀成形工艺
2.
Experimental Research on NC Bending with Small Bending Radius of Aluminum Alloy Thin-Walled Tube;
铝合金薄壁管小弯曲半径数控弯曲成形的实验研究
3.
The bending radius should not less than25 times of cable diameter.
电缆弯曲半径：不小于电缆外径的25倍。
4.
TUBE DIAMETER SHALL BE WITHIN 10% OF NOMINAL DIAMETER WITHIN BEND RADIUS.
管直径须在直径理论值和折弯半径的10%以内。
5.
This opens up the radius of the turn for you so the turn is less tight.
这会加大你过弯的半径，相对减小弯道的曲度。
6.
HEAVY DUTY AUTOMOTIVE STEERING, with shorter turning radius.
重型自动方向盘：较小的转弯半径。
7.
MANEUVERABILITY. Short turning radius, power steering.
灵活性：较小的转弯半径，动力转向。
8.
Mathematic calculation approach of minimum bending radius of mandrel based on Matlab
基于Matlab的芯轴最小弯曲半径计算
9.
Enter the ratio of the duct width to the inside radius of the bend. Enter '0' for no inside radius.
输入管道宽度与弯头内半径的比率。如果没有内半径，则输入“0”。
10.
MANEUVERABILITY. Short turning radius, less weight on the front axle.
灵活性：较小的转弯半径，前刚性轴上较轻的重量。
11.
The Structure and Seismic Response Analysis of a Small Radius Curved Box-Girder Bridge;
小半径弯箱梁桥的结构及地震响应分析
12.
The Calculation of the Minimal Turning Radius and the Setting of the Fire Road Width
消防车道最小转弯半径以及通道宽度的计算
13.
The pouring construction technology of small radius flat curve continuous steel bridge cantilever
小半径平弯曲线连续刚构桥悬臂浇筑施工技术
14.
Residual Collapsing Strength Analysis of Bending Part Casing in Medium/Short Radius Horizontal Wells
中短半径水平井弯曲段套管剩余抗挤强度分析
15.
Excellent pliability，flexibility and elasticity and suitable for special occasions requiring small bending radius.
本产品具有极好的弯曲、柔软性和弹性，可用于弯曲半径较小的场合。
16.
The Performance of Cold-formed Square Steel Columns Ultimate Axial Compressive Stress under Different Ratio of Radius to Thickness
弯角半径不同对冷弯矩形钢管柱轴心受压极限强度的影响
17.
Use to estimate turning radii for a typical small tractor with single semitrailer.
用于估计带有单节半挂车的典型小型牵引车的转弯半径。
18.
Drag onto the page to estimate turning radii for a typical single-unit truck or small bus.
拖到绘图页后，可以估计典型单节卡车或小型客车的转弯半径。