1.
Optimizing Combination of Expressway Excavation Slope Protection;
高速公路挖方边坡防护形式的优化组合
2.
The side slope losing the steady breakage mechanism and treating project in the superhighway inflation soil dig square
高速公路膨胀土挖方边坡失稳破坏机理及处治
3.
Automatic side-slope analysis algorithm of cutting-and-filling roads based on Digital Elevation Model(DEM)
一种基于数字高程模型的道路填挖方边坡自动解析算法
4.
Seismic fortification for high-filled embankment slope or deeply digging side road cutting slope
高填方路基边坡或深挖方路堑边坡抗震设防
5.
Rearch on the Application of the Stress Remolding Method to the Slope in Landside Correction;
应力重塑方法在开挖边坡治理中的应用研究
6.
Stability Mechanism Analysis of High Loess Excavation Slopes;
黄土挖方高边坡稳定性变化机理的分析研究
7.
The Compound Method for the Excavation Optimization and Stability Analysis of High Rock Slope
岩质高边坡开挖优化及稳定性分析的复合方法
8.
ESTIMATION OF CUT-FILL VOLUMES IN ROCK SLOPE ENGINEERINGBASED ON FRACTAL INTERPOLATION
基于分形插值的岩石边坡工程挖填方量估算
9.
MECHANISM INVESTIGATION AND TREATMENT OF SLOPE INSTABILITY AND TUNNEL COLLAPSE IN ANTI-DIP WITHIN THE LAYERED ROCK SLOPE EXCAVATION OF THE TUNNEL CONSTRUCTION
反倾层状岩质边坡内开挖隧道引发边坡失稳与隧道塌方的机制和治理研究
10.
The blasting of slope excavation results in the damage of rock mass consequentially.
边坡开挖爆破必然造成边坡岩体的损伤。
11.
Study on high excavated rock slope at TGP shiplocks
三峡船闸高陡岩石开挖边坡设计研究
12.
ANSYS Simulation of the Rock High-Slope Excavation and Consolidation;
岩质高边坡开挖与加固的ANSYS模拟
13.
Excavation Numerical Simulation of Cut Slope of Completely Weathered Granite
全风化花岗岩路堑边坡开挖数值模拟
14.
The slope designer is unlikely to be faced with unpleasant surprises when the slope is excavated.
边坡设计者不会在开挖边坡时遇到令人吃惊的坏情况。
15.
Researching on the Disturbed Zone for Cutting Bedding High Rock Slope & Calculation Method of Micro-pile;
顺层高边坡开挖松动区研究及微型桩加固边坡的内力计算
16.
The Excavation Blasting Technique of Particularly High and Steep Slope and the Influence on It s Stability;
特高陡边坡开挖爆破技术及其对边坡稳定性的影响
17.
Initial analysis on the measurement and locating methods of the toe line and top line in the excavation section
挖方段坡脚线及坡顶线的测量放样方法初析
18.
Such problems as the measurement of setting-out control points and topographic transformation lines, decision of working side slope lines and the application of gradient ruler and so on are elaborated in details.
对各种放样方法的控制点、形变换点的测设、挖边坡线的确定、度尺应用等问题作了具体说明。