1.
overhead cam shaft
上凸轮轴上部凸轮轴
2.
a gabled extension built out from a sloping roof to accommodate a vertical window.
屋顶斜坡上凸出的天窗。
3.
A protruding or receding part in a surface or line.
凸出（或凹入）部分在一个表面或线条上凸出或凹入的部分
4.
The camshaft has a cam, on which there is a lob, or bump.
凸轮轴上有一个凸轮，凸轮上有一个凸角。
5.
The cam may have three, four or six lobes.
该凸轮上有3个，4个或6个凸缘。
6.
As the lobe of the cam comes up under the cam follower, it pushes the cam follower upward (away from the camshaft).
当凸轮的凸角在凸轮挺杆下出现时，它推动凸轮挺杆向上运动(离开凸轮轴)。
7.
jut out or project in space.
在空间上突出或者凸出。
8.
The balcony juts out over the main street .
阳台凸出在街道上方。
9.
overhead camshaft engine
上置式凸轮轴发动机
10.
As the camshaft continues to rotate, the high spot moves way from the valve mechanism.
因为凸轮轴继续旋转，凸轮轴上的凸起部分离开气门装置。
11.
Design and Dynamic Simulation of Cam Automatic Feeding System for Assembled Camshaft
装配式凸轮轴凸轮上料系统设计及动力学仿真
12.
Semi-continuity and E-quasiconvexity of Functions on E-convex Set
E-凸集上的函数的半连续性与E-拟凸性
13.
Force the seal onto door flangContinue rearward until it is seated on flange.
用力将密封压到车门凸缘上，继续向后压直至它固定到凸缘上。
14.
"After the cam lobe moves out from under the valve lifter, the valve spring forces the valve up onto its seat again."
当凸轮凸角离开气门挺杆,气门弹簧使气门重新回到气门座上。
15.
Install a new cam bolt, cam and new nut in the axlRe-align the reference marks.
在轴上安装新凸轮螺栓，凸轮和 新螺帽。重新校准参考标记。
16.
Abnormal rearward curvature of the spine, resulting in protuberance of the upper back;hunchback.
脊柱后凸，驼背脊椎不正常地向后弯曲，导致背部上方凸出；驼背
17.
High-etch offset: A combination of relief and planographic printing using a right-reading relief plate on an offset machine. Also known as Dry offset, Letterset.
干柯式:是凸版和平版的结合。它用正读凸版，在柯式机上施印。
18.
Blind embossing: A general term for the process of raising an image using an un-inked block or die on paper or board.
素压浮凸:泛指用不着墨的电 或模在纸品上压成凸纹效果的方法。