1.
Injection mould for plastic large-size mould bases-Stop plates
GB/T12555.15-1990塑料注射模大型模架限位块
2.
In this paper, the nonlinear models of the leaf-spring shock absorber, elastic stop shocking and wheel hop are established.
本文建立了板簧、减震器和撞击限位块、车轮跳离现象的非线性模型;
3.
THE FINITE ELEMENT ANALYSIS OF THE END ANCHORAGE OF AN EXTRA-LARGE BIRIDE'S REHABILITATION ENGINEERING IN DONGPU OF GUANGZHOU CITY UNDER LARGER PRESTRESSING LOAD
广州市东圃某特大桥加固大吨位端部锚固块有限元分析
4.
rearmost position
最后位置，后部极限位置
5.
The Experimental Study on Cube Formation and the Finite Element Analysis on Cuber Components;
秸秆压块试验研究及压块机零件有限元分析
6.
Just take a stone and put it in the same place,
拿块石头，放回原位，
7.
The gentleman wanted to buy a cake,
这位先生想买块饼，
8.
materials that make a soft covering for a seat.
座位上的一块软垫子。
9.
Modular seat section. Attach to other modular seats and tables.
模块式座位部分。与其他模块式座位和桌子相连。
10.
Restrictions imposed by one might be reinforced by another.
一个模块产生了的限制，可能会被另一个模块强化此限制效应。
11.
The temperature of fuel pellets can be limited by linear power density restriction.
通过限制线功率密度,可以限制燃料芯块的温度。
12.
Pass the wire rope end through the weight for the limit switch.
将钢锁端头穿过极限开关的压块。
13.
We must limit ourselves to one cake each.
我们必须限定每人只吃一块蛋糕。
14.
a mark showing the boundary of a piece of land.
显示一块地的界限的标记。
15.
The discussion is cast in the context of an ascending parcel of air.
讨论限定在上升气块的情况。
16.
Reconsidering Modularity Theory:Limitation and Applicable Scope;
模块化理论的再审视:局限及适用范围
17.
Limit Cycles in a Temporal Morphogenesis Model;
关于颞部骨块形成模型的极限环问题
18.
Finite Element Analysis and Optimum Design of Plane Miller for Carbon Block
炭块平面铣床有限元分析及优化设计