1.
Analysis and Prevention on Defects of TX6113C Machine Tool and Column
TX6113C床身立柱变形缺陷的分析与防止
2.
Treatment of end-plate deformation defects by analyzing special specimen
从对特殊试件的分析看端板变形缺陷的处理
3.
Numerical Simulation of Process Mode and Deformation Defects on Multi-Point Forming;
多点成形时工艺方式与变形缺陷的数值模拟研究
4.
INFLUENCE OF STRENGTH PARAMETERS ON OVERALL DEFORMATIONS OF ROCK SPECIMENS WITH INITIALLY RANDOM MATERIAL IMPERFECTIONS
强度参数对初始随机缺陷岩样全部变形的影响
5.
Ten types defect of wrought aluminum and aluminum alloys rolling plates and sheets
十种常见的变形铝及铝合金轧制板材缺陷
6.
Closing and repairing process of Mg alloy casting imperfections in plastic deformation
镁合金铸造缺陷塑性变形弥合与修复过程
7.
Temperature Field Simulation of Casting Solidification Process and It's Defect Prediction of Shrinkage Cavity, Heat Distortion and Heat Crack;
铸件凝固过程的温度场模拟及缩孔、变形和热裂缺陷预测
8.
Construction of LuxS Gene Deficient Streptococcus Mutans and Detection of AI-2 Quorum-sensing Pathway;
变形链球菌LuxS基因缺陷株的构建及密度感应分子AI-2活性的检测
9.
The Change in P300 Wave of Children with Attention Deficit Hyperactivity Disorder before and after Taking Methylphenidate;
注意缺陷多动障碍儿童服用利他林前后P300波形变化的研究
10.
Numerical Simulation of the 3-D Deformation and Interior Defects Avoidance in Cross-Wedge Rolling Process;
楔横轧三维变形的数值模拟研究及内部缺陷预防
11.
On the Development and Deficiency of Reform System of the Form of Company Organization in The Law of Company in China;
试论《公司法》关于公司组织形式变更制度的发展与缺陷
12.
Compromise and Metamorphosis: The Theoretical Limitations of Traditional Translation Criticism;
妥协与变形——从“误译”现象看传统翻译批评模式的理论缺陷
13.
Effect of Pore Pressure on Failure Processes and Overall Deformational Characteristics of Rock Specimen with Random Defects
孔隙压力对含随机缺陷岩石破坏过程及全部变形特征的影响
14.
Relationship has been studied on defect to deformation degree, friction factor and relative length of mould plastic section.
同时，研究了表面缺陷产生与变形程度、擦因数及模具整形段相对长度的关系。
15.
Aesthetic defects of unilateral cleft lip nose and its repair
单侧唇裂鼻畸形的美学缺陷与修复
16.
The Establishment and Realization of f Graphic Base for Analysis of Car Cylinder Body Casting Defects
汽车缸体铸件缺陷分析图形库的实现
17.
Defects and Properties Analysis of Cemented Carbide by PIM;
注射成形硬质合金缺陷与性能的研究
18.
Study on the Defects Formation Mechanism and Control Methods in Resin Transfer Molding;
RTM工艺缺陷形成机理与控制方法研究