1.
Performance Research on RC Flat Plates with Opening Strengthened by External CFRP;
钢筋混凝土开孔平板外贴CFRP加固性能研究
2.
Stress Analysis and Structure Research for the Flat Plates with Openings and Rectangular Vessels;
平板开孔及矩形容器应力和结构的分析研究
3.
Hole Parameters Elastic Optimization and Material Selection for Plate with Holes
开孔板孔形参数的弹性优化及材料选择
4.
multicellular glass in blocks, panels, plates, shells or similar forms
多孔玻璃,呈块状、板条状、平板状、壳状或类似形状
5.
INVESTIGATION ON ASEISMIC BEHAVIORS OF STEEL MOMENT RESISTING FRAME INCLUDING OPENING IN BEAM WEB
梁腹板开圆孔的钢框架抗震性能研究
6.
Discussion on Deep Plate Loading Test by Self-balancing Method for Boring and Expanding Bottom Piles
扩底挖孔桩自平衡法深层平板载荷试验探讨
7.
Development of ANSYS Stress Design System For Large opened Strengthen Structure
开孔补强结构的有限元ANSYS平台开发
8.
The plate was loaded in its own plane by a pin passing through the hole in an annular disc fitted in the hole in the plate.
平板的孔里面镶嵌着一个套环，在此圆盘的孔中穿过一个销钉而使平板在其自身平面内受载。
9.
Influence of setting gap in the rear part of wharf deck and opening holes in deck on wave uplift forces
码头面板尾部开缝和面板上开孔对波浪上托力的影响
10.
an expressionless face, voice, tone, etc
呆板的面孔、 冷冰冰的声音、 平淡的声调等
11.
DETERMINATION OF THE RESIDUAL STRESSES IN EBW JOINT OF TITANIUM ALLOY PLATE BY HOLE-DRILLING METHOD
钛合金平板电子束焊接残余应力的小孔法测量
12.
SEAWATER DESALINATION BY VMD WITH IPP FLAT SHEET MICROFILTRATION MEMBRANES MODULE
聚丙烯平板微孔膜膜蒸馏海水淡化研究
13.
Fabrication of Poly(Vinylidene Fluoride) Flat Sheet Microporous Membrane via Thermally Induced Phase Separation;
热致相分离法制备聚偏氟乙烯平板微孔膜
14.
Investigation of Pore Structures of C/C Composite Plates by Mercury Intrusion Method
压汞法分析C/C复合材料平板的孔隙结构
15.
AN INVESTIGATION ON THE TENSION ANALYTICAL MODEL OF STEEL PLATE WITH STAGGERED BOLT HOLES
交错孔洞平板螺栓连接受拉分析模型研究
16.
Application of Gas Drainage in Fractured Zone by Roof High-level Boreholes in Daping Coal Mine
顶板高位钻孔裂隙带抽放在大平矿的应用
17.
Hall Effects on Hydromagnetic Flow on an Oscillating Porous Plate
振动的多孔平板上磁流体动力学流动的Hall效应
18.
Porous protective layer of the automobile planar-type ZrO_2 oxygen sensor
平板式汽车ZrO_2氧传感器多孔保护层研究