说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 相位阻尼
1.
Influence of Phase Decoherence on Quantum Teleportation before and after Purification in Cavity QED System;
腔QED纯化前后相位阻尼对量子传输的影响
2.
Effect of time-dependent coupling on linear entropies of the Jaynes-Cummings model with phase damping
时变耦合对含相位阻尼J-C模型线性熵的影响
3.
Decoherence of Relative Phase Damping in the Three-level Atom;
三能级原子中相对位相阻尼引起的消相干
4.
Research on Magnetoelectric Relative Displacement Self-Sensing Magnetorheological Dampers;
磁电式相对位移自传感磁流变阻尼器的研究
5.
DARACS (Damped Aerodynamic Righting Attitude Control System)
气动阻尼复位控制系统
6.
The dashpot displacement relaxes exponentially.
阻尼器位移按指数关系松弛。
7.
The Effect Analysis of the Vehicle Panel MOBILITY to the Damper Pad Position
轿车板MOBILITY特性对阻尼垫位置影响分析
8.
Investigation on Damping Coefficient of Torsional Vibration per Cylinder (Part 2)──Experiment in Variation with Crankangle
单位气缸阻尼系数问题的研究(二)──阻尼系数变化的实验分析
9.
Design and Research of MR Damper for Small Displacement & Big Damping Force
一种小位移大阻尼力磁流变阻尼器的设计与研究
10.
Research on Characteristics of Rubbing-pairs Reciprocity Damp in Dynamics;
摩擦副相互作用阻尼动力学特性研究
11.
The heavy damping makes it impractical to read gravity directly from the displacement of the beam.
高阻尼不能使其直接从横臂的位移读出重力值。
12.
Energy Decay Rate of the Plate Equation with Potential and Indefinite Damping;
含位势和不定阻尼项的板方程能量的衰减速率
13.
A Research on MRF-damper-based Pneumatic Positioning Control of Linear Actuator;
基于磁流变阻尼器的直线气缸位置控制研究
14.
Rotor Position Estimation of Salient-pole Permanent Magnet Synchronous Motor With Damper Windings
带阻尼绕组的凸极永磁同步电机转子位置估计
15.
Displacement-based design method for energy dissipation structures with nonlinear viscous dampers
非线性黏滞阻尼减震结构基于位移的设计方法
16.
Non-isothermal crystallization kinetic study on flame retardant nylon 6 via in-situ polymerization
原位复合阻燃尼龙6的非等温动力学研究
17.
This method is especially accurate in damping identification with the relative error less than 1% to theoretic values.
尤其在阻尼比的识别上,相对误差在1%以下。
18.
Photographic ECM of Group Holes on Air Conduct Damper Bushing
空气导管阻尼套群孔照相电解加工技术研究