1.
Casting Process Design and Manufacture for Nozzle Chest Casting of Super-critical Pressure Turbine
超超临界汽轮机喷嘴室铸造工艺设计及其生产
2.
Design and Hydro-test Procedure of Hydro-test Device for Spray Nozzle Connector of Double-housing Steam Turbine
双缸汽轮机喷嘴组连接器的试压工装设计及工艺简介
3.
Correction of Temperature Display in Governing Stage of Nozzle Governing Steam Turbine Unit
喷嘴配汽汽轮机组调节级温度的修正
4.
ASME Flow Nozzles and GB/T 2624-93 Flow Nozzles Calibration for Turbine Testing
汽轮机性能试验ASME流量喷嘴及GB/T2624-93喷嘴校验
5.
twin wheel twin nozzle type turbine
双轮双喷嘴式水轮机
6.
turbojet performance
涡轮喷汽发动机性能
7.
Passing through the nozzle at the highest speed, Impulse turbine steam directs against a row of blades which assembled in the axles of Impulse turbine with radiation shape.
当蒸汽以最高速度从喷嘴里喷出时，便冲击一列呈辐射状安装在涡轮机主轴上的动叶片。
8.
Experimental research of air atomization injector using in some gas turbine
某燃气轮机空气雾化喷嘴的试验研究
9.
Effect of VNT Nozzle Opening on Performance and Emissions of an Automotive Diesel Engine;
可变喷嘴涡轮增压器喷嘴截面积对车用柴油机性能的影响
10.
In practice, the turbine disc and the nozzles are fitted into a casing.
实际上，涡轮圆盘和喷嘴是装在机壳里的。
11.
FSI Calculation and Analysis of Nozzle System in Pelton Turbine
冲击式水轮机喷嘴系统流—固耦合计算与分析
12.
Experimental Study on the Atomization Behavior of Fuel Injector Group of a Heavy-Duty Gas Turbine
某重型燃气轮机喷嘴组雾化特性的试验研究
13.
Experimental Study of the Nozzle Group Flow Characteristics of a Heavy-duty Gas Turbine
某重型燃气轮机喷嘴组流量特性试验研究
14.
Numerical Simulation of the Influence of Liquid on Corrosion of Nozzle-control Room of Underwater Power Generator
流体对水轮机喷嘴控制室腐蚀影响的数值模拟
15.
Experimental Study of Double Fuel Injector Group of Heavy-duty Gas Turbine
某重型燃气轮机双燃料喷嘴组试验研究
16.
steam atomizing conical jet
蒸汽雾化圆锥形喷嘴
17.
high pressure nozzle spray drier
高压喷嘴式喷雾干燥机
18.
Three Dimension Modeling and Strength Analysis of Multi-jet Turbine;
多喷嘴冲击式水轮机转轮的三维建模与强度分析