1.
Calculation Method Research of the Interference Fit for High Speed Motorized Spindle Bearings
高速电主轴轴承配合过盈量的计算方法研究
2.
Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle
油气润滑技术在高速电主轴轴承上的应用
3.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
4.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
5.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
6.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
7.
Crankshaft and main bearings service
曲轴和主轴承的维修
8.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
9.
Experimental Research on Oil-Air Two Phase Lubrication of High Speed Motorized Spindle Rolling Bearing;
高速电主轴滚动轴承油气两相流润滑试验研究
10.
The Application of Ceramic Bearing Electric Spindle on High-speed and Precise Grinding Machine;
陶瓷轴承电主轴在高速精密磨床中的应用
11.
Analysis to Connecting Shaft Fracture between Motor Reducer and Main Bearing of Cutting Disc of a Shield
盾构电机减速器与刀盘主轴承连接轴断裂分析
12.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
13.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
14.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
15.
Analysis of Lublication and Failure for Thrust Bearing in Cold Mill Main Motor
冷轧主电机止推轴承润滑与故障分析
16.
Research on the Load Capability of the Motored Spindle of Oil-air Lubricated Dynamic-static Slide Bearing;
油气二相流动静压滑动轴承电主轴承载性能研究
17.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
18.
It is studied the existing three kinds of bearing arrangement for the driving gear shaft of locomotive motor.
研究了现有的3种机车电机主动齿轮轴轴承布置方式。