1.
The periodic variation in speed of a synchronous motor with respect to the current.
（同步电动机的）速度偏差同步电机运行速度的周期性变化
2.
accelerometer drift
加速计的偏差[偏移]
3.
Scale factor and bias calibration of electrostatic accelerometer
静电加速度计标度因数和零偏误差标定
4.
Migration Velocity Error Analysis Based on the Acoustic Wave Equation;
基于声学波动方程的偏移速度误差分析
5.
Speed and Position Observer of DFIG Based on Rotor Current Vector Angle Deviation
基于转子电流偏差角的双馈感应电机速度观测
6.
The accelerometer bias errors result in an average constant offset plus an oscillatory component.
加速度计的偏置误差形成一平均的常值偏离加上一振荡分量。
7.
Since there is deviation of gear angle, gear box may be damaged while starting engine.
但由于变速箱内啮合角度的偏差,起步驱动时会造成变速箱损坏。
8.
Therefore, the method is easy and quick to operate and of high precision and its standard deviation is below 0.084%.
本法操作简便、迅速、精密度高,平行试验结果标准偏差为±0.084%.
9.
Influence of Face Coning and Static Stator Angular Misalignment on Dynamic Behavior of Gas Film of Slow Speed Dry Gas Seal
锥度及静态静环角偏差对低速干气密封气膜动态特性的影响
10.
Influence of Face Roughness and Static Stator Angular Misalignment on Steady-state Behavior of Low Speed Dry Gas Seal
端面粗糙度及静环静态角偏差对低速干气密封稳态特性的影响
11.
Tolerance of Wire Diameters & Ovality
圆径及偏圆度之公差
12.
Checking Rotor Runout And Thickness Variation
检查转子的偏摆和厚度的偏差。
13.
Simulation of the Multiple Velocity and Acceleration Difference Model
加速度差与多速度差模型的数值模拟
14.
To all interpolate method of CNC system,the minerror method is a interpolate with higher accuracy and faster speed.
数控系统各种插补方法中 ,最小偏差法是脉冲增量方法中精度最高、运算速度最快的插补方法。
15.
Limit deviations of angle without tolerance indication
GB/T11335-1989未注公差角度的极限偏差
16.
Timing Control Positive Governing Governor Deviation
正时控制正调节调速偏差
17.
The Fast Algorithm of Circular Arc Interpolatio with Negative Deviation Character;
具有负偏差特性的快速圆弧插补算法
18.
Diameter Tolerance, Ovality and Average Decarburized Layer Depth
直径公差，偏圆度及脱碳层的平均深度