1.
A Research into the Basic Formulation of the Calculation of the Welded Seam Strength of Right-Angle Welded Seam;
关于直角角焊缝强度计算基本公式的探讨
2.
This paper analyses the cause of strength descent of brazing weld, and proposes improving measures.
本文分析了钎焊焊缝强度下降的原因,并提出改进措施。
3.
Regression and Analysis on Metal Strength of Welding Seam of Welding Core Wine
药芯焊丝焊缝金属强度的回归与分析
4.
"Where thickness characteristics at the joint are more important than strength, a thinner welder is possible at reduced joint strength. "
如果焊缝的厚度比强度更重要,则在降低强度条件下可使焊缝更
5.
The Influence of Intricate Edge of Welded Seams in Thin-walled Pressure Vessels on Strength
薄壁压力容器焊缝错边对强度的影响
6.
J-Integral Test and Residual Strength Analysis for Steel 907A and Its Weld;
907A钢及焊缝金属的J积分测试与剩余强度分析
7.
Initiation Mechanics of Fatigue Crack at Weld Joint of High Strength Bridge Steel
高强度桥梁钢焊缝疲劳裂纹萌生机理的研究
8.
Latest Development of Fatigue Strength Analysis Technology for Welds in Steel Structures
钢结构焊缝疲劳强度分析技术的最新进展
9.
Experiment on tensile and shear strength of front fillet welded joint post-high-temperatures
高温后正面角焊缝抗拉剪切强度的试验
10.
insufficient or excess reinforcement of weld
加强焊缝不足或过量
11.
"High strength steels may result in increased thickness, however, the resulting joint is strong, smooth and recoilable. "
高强度钢可能更厚些,但是,焊缝是强固的,平滑的,可重卷的。
12.
With fine ability to clear off oxidation film, The width of clearing film can be adjusted continuously to make out good-looking welding seam.
超强清理氧化膜能力，清理宽度连续可调，焊缝光亮美观。
13.
Flux entrapped in the joints is the principal cause of low strength or failure.
裂缝中封存有焊药是强度不足或断裂的主要原因。
14.
STUDY ON REDUCTION FACTOR OF FATIGUE STRENGTH AND DISPERSION COEFFICIENT OF LIFE IN SEAM WELDED JOINTS
缝焊接头疲劳强度降低系数和寿命分散系数的研究
15.
Study on Influences by Straight Welding Processes on Welded Pipe Tensile Strength(Part Ⅱ)
直缝焊管制造工艺对钢管拉伸强度影响的研究(下)
16.
Study on Influences by Straight Welding Processes on Welded Pipe Tensile Strength(Part I)
直缝焊管制造工艺对钢管拉伸强度影响的研究(上)
17.
Indicates concave, convex or flush welds. Increase height to fit above other weld symbol.
指示凹焊缝、凸焊缝或平焊。增加高度以配合其他焊接符号。
18.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨