1.
band wheel pumping power
深井泵抽油的皮带驱动
2.
This shall erect bell cleanup scrapper in front of belt-drive roller, so that this clean up crude coal adhered onto belt.
皮带驱动辊筒前安装有皮带清洁刮板，清除粘结于皮带上的原煤。
3.
"Oil pressure is provided by a high pressure oil pump that, generally is belt driven by the engine."
油压是由高压油泵提供的,发动机通过皮带驱动油泵。
4.
The engine fan is usually mounted on the water pump shaft and is driven by the same belt that drives the pump and the generator.
发动机风扇通常安装在水泵轴上,由驱动水泵和发电机的同一条皮带驱动。
5.
"The water pump, driven by a belt from the engine crankshaft, circulates the cooling liquid between the radiator and engine water jackets."
水泵由发动机曲轴上的皮带驱动,使冷却液在散热器与发动机水套之间循环流动。
6.
Remove serpentine drive belt, refer to Group Cooling.
拆下蛇型驱动皮带，请参阅单元7-冷却。
7.
Loose accessory drive belt (water pump slipping).
辅助驱动皮带松脱（水泵打滑）。
8.
Design and Construction of Large Section Driving Chamber in Blind Belt Slope
皮带暗井大断面驱动峒室设计与施工
9.
For belt tension specifications, refer to Specifications-Accessory Drive Belt in this group.
关于皮带张力规格表，请参见本单元的规格表-辅助驱动皮带
10.
The engine drive belt should be replaced any time the tension is released or it is removed.
任何时候释放张力或将皮带拆下，引擎驱动皮带就要更换。
11.
Install accessary drive belt (refer to Group 7, Cooling).
安装附属的驱动皮带（请参阅单元7，冷却）。
12.
The generator is usually mounted on the side of the engine Block. It is driven by the engine fan belt.
发电机通常装在发动机机体的一侧,由发动机风扇皮带来驱动。
13.
When the belts have been located in the belt pulley grooves,moves the drive motor away from the driven shaft so that uniform teensioning of the belts is achieved.
在安装新皮带时，要用手动的方式使电机向驱动轴移动而使所有皮带均处于滑轮槽内。
14.
Loosen the accessory drive belt at the power steering pump bracket, if equipped or at the idler pulley bracket (refer to Group 7, Cooling System for the proper procedure).
如果装备且在惰轮皮带盘托架上，放松动力转向泵托架上的附件驱动皮带。
15.
Loosen the accessory drive belt tension and remove the belt from the power steering pump (refer to Group 07, Cooling Systems for proper procedures).
放松辅助驱动皮带，从动力转向泵上拆下皮带（有关程序，请参阅单元07，冷却系统）。
16.
The belts have teeth, or slotted spaces to engage and drive teeth on gear wheels.
皮带上有齿，或者槽以啮合并且驱动传动齿轮上的齿。
17.
The Application of Frequency-Conversion Driving in the Conveyer System of Shanghai Port Luojing Ore Terminal
变频驱动技术在上海港罗泾矿石码头皮带输送系统中的运用
18.
pinch solenoid driver
压带电磁线圈驱动器