1.
A Discussion on Measurement Method by Using Hydraulic Jet Pump in Well Testing
利用水力喷射泵试产的油水计量方法探讨
2.
Oil-water two-phase flow measurement using vortex flowmeter
利用涡街流量计测量油水两相流流量
3.
Research on High-Water-Cut Oil-Gas-Water Multiphase Flowmeter;
高含水率油、气、水多相流量计的研究
4.
The Application of Coriolis Mass Flowmeter in Oil Field for Metering Rude Oil Containing Water
科里奥利质量流量计在油田含水原油计量中的应用
5.
Calculation method of critical production rate for fractured-vuggy reservoir with bottom water
塔河油田缝洞型底水油藏临界产量计算研究
6.
Analysis and Calculation of Flow Rate of Vent Gas From Sour Water Tanks in Refinery
炼油厂酸性水罐区排放气量分析计算
7.
Calculation Method of Oil-Paper Insulation Moisture Content Based on Oil-Paper Moisture Equilibrum of Transformer
基于变压器油纸间水分平衡关系的油纸绝缘水分含量计算方法
8.
ABSTRACT: This paper provides formula of critical production computation of oil wells in reservoir with bottom water and confing bed, which is suitable for all wells in reservoirs with bottom water and confing bed.
本文给出了带隔板底水油藏油井的临界产量计算公式,它适用于所有带隔板底水油藏的油井。
9.
initial breakthrough recovery
油井见水时的采油量
10.
The Design and Research on Online Sensor of the Water in Oil Used in Crude Oil Tank;
原油罐含水在线测量传感器的设计与研制
11.
Model for prediction of crude oil water content at wellhead metering based on CPN neural network
基于CPN网络井口计量原油含水率预测模型
12.
Calculation of oil reserves by means of C-type water-flooding curve
利用丙型水驱曲线计算油田储量的方法
13.
Deduction on Equation of Water Ratio in Oil with Microwave Method
微波法测量原油含水率计算公式的推导
14.
DESIGN OF PARTIAL SIMILARITY MODELS AND THEIR EVALUATION METHOD IN WATER FLOODING PHYSICAL SIMULATION
水驱油局部相似模型的设计及定量评价方法
15.
A calculation method for estimation cooling water volume is presented for designing the cooling water system for diesel engine.
针对柴油机冷却水系统,提出一种估算冷却水量的计算方法。
16.
OIL SEPARATION DESIGN FOR PRETREATMENT OF OILY WASTEWATER IN REFINING UNITS
炼油装置含油污水预处理的隔油设计
17.
A kind of on-line crude oil measurement and management system based on real-time water cut and gas cut transducer is introduced.
介绍了一种集原油温度和含水含气实时测量与显示于一体的在线式原油自动计量管理系统。
18.
Optimization of Horizontal Well Design of E_3~1 Reservoir with Bottom Water in X Oilfield
X油田Es_3~1底水油藏水平井设计优化