1.
Research on Process and Key Technologies of Collaborative Design and Manufacturing for Aero Engine
航空发动机设计制造协同流程及关键技术研究
2.
General Analysis Software Design of Aeroengine Internal Air System
航空发动机内流空气系统通用分析软件设计
3.
Pulse Pressure DAQ Module Designed for Turbine Aeroengine
航空涡轮发动机脉动压力参数采集模块的设计
4.
Research and Design for Aero-Engine High-Speed Accesory Transmission System;
航空发动机高速附件传动系统研究和设计
5.
Design of Aeroengine Life Monitor System Based on Flight Data
基于飞行数据的航空发动机寿命监视系统设计
6.
Simulation and Design of a Piston Aeroengine Cooling System;
活塞式航空发动机冷却系统性能仿真与设计
7.
Research on Aero-engine Fuzzy Control System with Multi-Objective Genetic Algorithm Optimizing;
航空发动机模糊控制系统多目标优化设计研究
8.
The Design and Validation of BIT for Aero-engine Electronic Controller;
航空发动机电子控制器BIT设计及验证技术研究
9.
Critical technologies for aero-engine prognostics and health management systems development
航空发动机预测健康管理系统设计的关键技术
10.
Aviation-engine lubricant system fault diagnosis based on LabVIEW
基于LabVIEW的航空发动机滑油故障检测系统设计
11.
Design of an adaptive decoupling controller of aero-engine over whole envelop
航空发动机全包线自适应解耦控制器设计
12.
Design and Validation of Aero-engine Two Degrees-of-Freedom Robust Controller
航空发动机二自由度鲁棒控制器设计与验证
13.
Design of Full Flight Envelop Controller for Aero-Engine
航空发动机全飞行包线鲁棒控制器设计研究
14.
Design and simulation of afterburner state control system of aero engine
航空发动机加力状态控制系统设计与仿真
15.
Study of robust linear parameter varying filter design for aeroengines
航空发动机鲁棒线性变参数滤波器设计
16.
Design of preamplifier for aero-engine electrostatic sensor
航空发动机静电传感器前置放大器设计
17.
Design and Simulation of Measuring Equipment of Gas Temperature of Aeronautic Engine
航空发动机燃气温度测量装置的设计与仿真
18.
Design and Calculation of the Aeroengine P_2 Pressure Measurement Devices Based on SIMULINK
基于Simulink的航空发动机P_2压力测量装置的设计计算