1.
Mechanisms and Techniques for Deep Sawing of Granite;
花岗石超大切深锯切机理与技术研究
2.
drunken saw
【机】切[开]槽锯
3.
Analysis of High Speed Forming of Serrated Chip Based on Mechanism of Slip-Stay-Slip
基于滑—停—滑机理的锯齿形切屑高速成形分析
4.
Study on Concrete Sawing Mechanish and Single Segment Cutting Concrete;
混凝土加工机理及单节块锯切混凝土研究
5.
Study on Electroplated Diamond Wire Saw Slicing Single Crystal Silicon Technology and Mechanism
电镀金刚石线锯切割单晶硅技术及机理研究
6.
stitch pinking machine
锯齿边布样切裁缝纫机
7.
Study on FEM-Based Incising Mechanism of Saw-Tooth Type Cutter for Arundo Donax L.;
基于有限元法的锯齿式芦竹切割器切割机理研究
8.
As compared with the practically-measured results, the analysis and the calculation theory established in this paper about cutting noise of the small-sized disk saw machine is correct.
理论计算值与实测结果的比较表明，所建立的圆盘锯机锯切噪声分析及计算理论是正确的。
9.
The Research and Development of the Cutting Parameters Optimization System Used for Circular Saw;
木工圆锯机锯切参数优选系统的研究与开发
10.
Design of Hot-Sawing Lamping Device and Hydraulic Calculation
热锯机锯切夹紧装置的设计及液压计算
11.
Research of Processing Principle and Development of Experiment Setup for Electroplated Diamond Wire Saw with Ultrasonic Vibration;
电镀金刚石线锯超声波切割实验装置的研制和加工机理的研究
12.
Study on the Hard-brittle Machining Technology and Mechanism Based on Ultrasonic Vibration Assisted Electroplated Diamond Wire Saw;
基于超声振动—电镀金刚石线锯切割硬脆材料技术及机理研究
13.
Terminology for metal-cutting machine tools--Sawing machines
GB/T6477.13-1986金属切削机床术语锯床
14.
Discussion on the Walking Mechanism Fault of Mill-Cut Saw and Improving Measures
磨切锯走行机构问题分析及改进措施
15.
a handsaw for cutting with the grain of the wood.
按木头的纹理切割的手锯。
16.
top plate cutting angle
顶片切削角 -锯链
17.
SCR REVERSIBLE HAULING SYSTEM OF THE CARRIAGE OF BANDSAW WITH THE CONTACTOR CHANGE-OVER
带锯机跑车拖动接触器切换的可控硅可逆系统
18.
single-blade stroke circular
单锯片往复式圆锯机