1.
Influence of setting error of grinding wheel truer on the truing accuracy in angular approach cylindrical plunging grinding
端面外圆切入磨削时修整器安装误差对修整精度的影响
2.
The Research on Accuracy and Efficiency for Laser Truing and Dressing of Bronze-bonded Diamond Wheels by Acoustic-optic Q-switched Nd:YAG Pulsed Laser
声光调Q Nd：YAG脉冲激光修整青铜金刚石砂轮精度和效率研究
3.
Precision grinding is concerned with grinding to close tolerances and very smooth finish. Non-precison grinding involves the removal of metal where accuracy is not important.
精磨是为了紧工差和高光面修整的磨削,而非精磨是精确度要求不高的金属切削。
4.
BigInteger supports arbitrary-precision integers.
BigInteger支持任意精度的整数。
5.
The steel square is used for laying out and trying up right angles.
钢尺用于设计并精确修整直角。
6.
Design precision, with up and under, right andleft, front and bank adjusted screw, theadjustment is high accuracy, and fast.
设计精巧，设有上、、、、、调整螺杆，调整精度高，科学快捷。
7.
Test Results and Accuracy Analysis of the Terminal Correctional Sub Projectile Sensor
末修子弹敏感器试验结果及精度分析
8.
Development on Auto Amending Device for Linearity of Precise Potentiometer;
精密电位计线性度自动修刻台的研制
9.
Process Argument and Implement of Overhauling the Utraprecise Boring Fixure
大修超高精度镗模的工艺论证与实施
10.
Investment Precision Control of Maintainability Rise for Active Equipment
现役装备维修性增长的投入精度控制
11.
One complete set of CMM measuring report.
3一套完整的三坐标精度测量报告。
12.
The Analysis of Spatial Data Precision on the Land Consolidation;
土地整理项目中空间数据的精度分析
13.
Design of a 7.5V High Precision BiCMOS Voltage Regulator
7.5V高精度BiCMOS电压调整器的设计
14.
After correction, the estimates of signal amplitude and frequency have high accuracy.
修正后的信号强度和频率估值有相当高的精度。
15.
Experimental Research on Grinding Temperature of ZrO_2 in Ultrasonic Grinding Dressed by Elliptic Vibration
椭圆振动修整超声磨削ZrO_2温度试验研究
16.
In-flight mathematical rectification scheme for high-precision INS
高精度平台惯导系统空中数学修正方法
17.
Research of Error Correction in High Accurate Large Shaft Measurement System by Using Idler Wheels;
高精度滚轮法测量系统误差修正技术研究
18.
The Accuracy Design and Error Correction of Nano Coordinate Measuring Machines;
纳米三坐标测量机的精度设计与误差修正