1.
Lightly lubricate pilot bearing with Mopar® high temperature bearing grease.
用Mopar®高温轴承黄油轻轻地润滑引导轴承。
2.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
3.
The Determination of the Critical Technical Supply Pressure of the Rubber Guide Bearing of the Axial Pump
轴流泵橡胶导轴承技术供水临界压力的确定
4.
As lubricated with outside clean water, bearings are of long life.
导轴承由外接清洁水润滑，使用寿命长。
5.
Dynamic Coefficients of Tilting Pad Guide Bea-rings of Hydraulic Turbine Sets, Power Engineering
水电机组可倾瓦导轴承动力特性系数
6.
Lubrication Performance Study on Guide Bearing for Hydropower Sets;
水轮发电机组水导轴承润滑性能分析
7.
The slide bearing assembled in middle segment is separated from sewage by inside pipe.
中间节设有由内导管将污水隔离的滑动导轴承。
8.
Treatment on oil throw fault in lower guide bearing of generator of Shuibuya Hydropower Plant
水布垭水电站发电机下导轴承甩油问题处置
9.
The Installation and Test of the Hydraulic Turbine Guide Bearing of Three Gorges Right Bank Power Station
三峡右岸机组水导轴承安装及调试特点
10.
The carriage is supported on guide shafts.
托架支承在导轴上。
11.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
12.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
13.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
14.
The Study on the Hybrid High-Temperature Superconducting Magnetic Bearing System;
高温超导混合磁悬浮轴承系统的研究
15.
Numerical Calculation and Experiment of High Temperature Superconducting Magnetic Bearings;
高温超导磁悬浮轴承数值计算与实验
16.
Research on the Analytical Magnetic Force Model of Permanent Magnet Bearings Andpermanent Magnet Guideway;
永磁轴承和导轨磁力解析模型的研究
17.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
18.
plain bearing housing with bearings
装有轴承的普通轴承座