1.
Study on the Boundary Condition of Inlet Oil Temperature of Energy Equation for EMP Pad by Boundary Layer Theory
利用边界层理论确定弹性金属塑料瓦油膜能量方程的进油温度边界条件
2.
Experimental study of influence of inlet temperature on aviation kerosene coking characteristics
进口温度影响航空煤油结焦特性实验
3.
The Effects of Intake Oxygen Concentration on the Combustion and Emission Characteristics of the Diesel
进气氧浓度对柴油机低温燃烧影响的试验研究
4.
Improvement of Process Gas Temperature Control in Oil-fueled Pneumatic Tobacco Drier
燃油管道式烘丝机工艺气体温度控制的改进
5.
Measures to reduce the temperature of oil are suggested after concurrent analysis of cooling system.
并对冷却系统进行了分析探讨,提出降低柴油机机油温度的建议。
6.
oil thermometer
（发动机）机油温度表
7.
Effect of Stable Hot Oil Temperature Field on Cold Oil Temperature in Process of Batch Transportation
稳定的热油温度场对后续冷油温度的影响
8.
A STUDY OF COLD FLOW IMPROVERS FOR SOYBEAN BIODIESEL FUEL
大豆油生物柴油低温流动改进剂研究
9.
Numerical Simulation on Soil Temperature Field and Heat Drop in Hot Crude Pipeline
热油管道温降及土壤温度场数值模拟
10.
Effect of Air Temperature and Oil Temperature on Mist Characteristics of Oil Mist Lubrication Device
空气温度及油温对油雾发生器雾化特性的影响
11.
Computation of Lubricant Temperature at Outlet of Accessory Gearbox
附件机匣出油口润滑油温度计算方法
12.
Oil temperature automatic monitoring system design in the oil wells station
油田井站输油温度自动监控系统设计
13.
stage or degree of progress,increase,temperature,etc
（进展、增进等的）阶段,程度;（温度等的）度
14.
Liquid petroleum products--Viscosity-temperature charts
GB/T8023-1987液体石油产品粘度温度计算图
15.
Film Strength Ability of a film of lubricants to resist rupture due to load． Speed and temperature.
油膜强度润滑油油膜抵抗因负荷、度和温度而造成破裂的能力。
16.
Film Strength Ability of a film of lubricants to resist rupture due to load．Speed and temperature.
油膜强度润滑油油膜抵抗因负荷、速度和温度而造成破裂的能力。
17.
Causes Analysis and Improvement about the Mill Hydraulic Station Oil Temperature Too High
磨煤机液压油站油温过高的原因分析及改进
18.
all bearings shall be permanently lubricated with a premium moisture resistant grease containing rust inhibitors and shall be suitable for operation over a temperature range of -25 C to +120 C.
所有轴承都应该采用温度范围在-25℃至+120℃之间的防潮、防锈油脂进行永久润滑。